Installation guide

9. Blade Assembly.
motor
housing
blade
blade
attachment
screws
and washers
blade arm screw
lock washer
Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor (save blade arm screws and lock
washers to secure blade arms). Align blade arm
holes with motor screw holes and attach blade arm
with lock washers and blade arm screws. Before
securing screws permanently, repeat with
remaining blade arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
scroll arm
support
scroll arm
support
scroll arm
motor housing
8. Scroll Arm Assembly.
Remove 3 decorative screws from inside top of
motor housing. Remove decorative screws from
scroll arm support.
Attach scroll arm to motor housing first. Align
hole in larger end of one of the scroll arms with
hole in top of motor housing--use decorative
screw that was previously removed to secure
scroll arm to motor housing. Adjust scroll arm
support to the proper height and then secure
the scroll arm to the scroll arm support with one
of the decorative screws that was previously
removed. Repeat for the remaining scroll arms.
Secure scroll arm support to downrod by
tightening the 3 set screws in the scroll arm
support.
decorative
screws
decorative
screws
downrod
motor housing
scroll arm
support
fixture screw
blade arm
page 7