Operator`s manual

45
DESCRIPCIÓN cont.
La Sierras Circulares ofrencen las siguientes características: cont.
Fig. 3
Tornillo de
sujeción del
husillo
Base
Palanca de
bloqueo para
ajuste del bisel
Escala del bisel
Tornillo de
retención/sujeción
del borde guía
Ranuras de
montaje para
el borde guía
Mango delantero
de asistencia
Protector inferior
de la hoja
Palanca del protector
inferior de la hoja
Mango posterio
Interruptor gatillo
Protector
superior
de la hoja
Cubierta
del motor
Hoja
Botón de bloqueo del husillo
Base
Palanca del
protector
inferior de
la hoja
Escala para
corte en
profundidad
Mango
delantero de
asistencia
Cubierta del motor
Llave de la hoja se
almacena en la base
7
1
®
Amps
12
7
1
®
Amps
13
9-10866 - Innovador
Bevel Trac™ “Indicador de
linea de corteo automatico”
ESPECIFICACIONES DEL PRODUCTO 9-10865
Entrada
Clasificación
Velocidad sin carga
Profundidad de corte a 90°
Profundidad de corte a 48°
Ángulo máximo de biselado
Diámetro de la hoja
12 Amps
120V, 60Hz AC
4800 RPMs
2
7
/ 16 pulgadas (61.97mm)
1
13
/ 16 pulgadas (46.03 mm)
48°
7
1
/ 4 pulgadas (184 mm)
7-24-06
16
DESCRIPTION cont.
OPERATION
SAW BLADES
All saw blades need to be kept clean,
sharp and properly set in order to cut
efficiently. Using a dull blade places a
heavy load on the saw and increases
the danger of kickback. Keep extra
blades on hand, so sharp blades are
always available. Gum and wood pitch
hardened on the blade slows the saw
down. Use gum and pitch remover,
hot water or kerosene to remove them.
DO NOT use gasoline.
BLADE GUARD SYSTEM (Fig. 4)
The lower blade guard, attached to
your circular saw, is there for your
protection and safety. It should
NEVER be altered for any reason.
If it becomes damaged or begins
to return slowly or sluggishly,
DO NOT operate your saw until the damage has been repaired or replaced.
ALWAYS leave the guard in its correct operating position when using the saw.
Fig. 4
Blade 1/4-in. or less
is Exposed on
Underside of Workpiece
Lower Blade
Guard lever is
in UP position
when making
a cut
CAUTION: NEVER use the saw when the guard is not operating properly. The
guard should be checked for correct operation before each use. If you drop your saw,
check the lower blade guard and bumper for damage at all depth settings before using.
NOTE: The guard is operating properly when it moves freely and then readily returns to
the closed position. If for any reason your lower blade guard and bumper does not close
freely, take the saw to your nearest Sears Repair Center for service before using it.
!
Lower Blade
Guard retracts
automatically
when cut is
being made
®
PRODUCT SPECIFICATIONS 9-10866
Input
Rating
No Load Speed
Cutting Depth at 90°
Cutting Depth at 55°
Maximum Bevel Angle
Blade Diameter
13 Amps
120V, 60Hz AC
5200 RPMs
2
7
/ 16 -in. (61.97mm)
1
15
/ 32 -in. (37.3 mm)
55°
7
1
/ 4 -in. (184 mm)