Owner`s manual

ACCESSORIES INCLUDED WITH YOUR PLANER
To make yourplaner evenmore versatilewe have included2 special
accessories. They are an Edge Guide and a Rabbeting Plate.
ATTACHINGTHE EDGE GUIDE
(See Figure 5)
1. Unplugyourplaner.
I /_ WARNING: Failureto unplug I
yourplanercould resultinaccidental
starting,causingseriousinjury.
2. Insert the screw providedthroughthe
hole in the edge guide.
3. Tighten screw securely into screw hole
on either side of the main shoe
(see Fig. 5).
USING THE EDGE GUIDE
The Edge Guide easily attaches to either side of the planer. It is ideal for
planing long and uneven boards.
1. When making cuts with the Edge Guide ALWAYS hold it firmly against the
edge of the board you are planing.
ATTACHINGTHE RABBET GUIDE (See Fig. 6)
1. Unplug yourplaner.
/_ WARNING: Failureto unplugyourplanercouldresultin accidental I
starting,causingseriousinjury.
I
2. Insert the screw provided throughthe flat washer, then throughthe slot in
the rabbetingplate,
3. Insert screw intoscrew hole on the
rightside of the main shoeand
tightensecurely (see Fig.6).
USING THE RABBET GUIDE
The Rabbet Guide attaches to the right
side of the planer. It is ideal for making
rabbeting cuts up to 15/16 inches thick.
The maximum width of cut is 15/16-inch
per cut.
1. When making a rabbet cut, ALWAYS
place the notch on the inside of the
main shoe firmly against the side of
the board (see Fig. 6).
2. ALWAYS press the Rabbet Guide
firmly against the top surface of the
board. 13
Nolch