Owner`s manual

TO ADJUSTTHE DEPTH OF RABBEt" CUT
1. Unplug yourplaner.
I /_ WARNING: Failureto unplugyourplanercouldresult in accidental istarting,causingseriousinjury.
2. Place planeron a flat board or work piece.
3. Loosen the screwand positionthe bottom surfaceof the Rabbet Guide above
the boardthe same distanceas the desired depthof cut.
4. Tightenscrew securely.
REPLACINGTHE BLADES (See Figures 7 to 9)
The blades in thisplaner are reversible,so when the blades become dull,
theycan be reversed.
ALWAYS REPLACE OR REVERSETHE BLADES IN PAIRS.
DO NOT ATTEMPTTO SHARPEN THE BLADES.
NEVER OPERATE YOUR PLANER WITH ONLY ONE BLADE INSTALLED.
1. Unplug yourplaner.
I _, WARNING: Failuretounplugyourplanercouldresultinaccidental
starting,causingserious injury.
2. Place the planer upside down on the work bench. (See Fig. 7).
3. Use the wrench (included) to loosenthe 3 bolts that hold the blade to the
blade clamp.To loosen bolts, turn them approximately 1/2 turn in a clockwise
direction. (See Fig. 7).
4. Hold the blade clamp in position and use a piece of wood to slide the blade
out of blade clamp. (See Fig. 8).
5. Push down on blade guard when removing the blade from the blade clamp.
(See Fig. 8),
Fig. 8
of
Wood
Work
Bench
14