Owner`s manual

REPLACINGTHE BLADES (See Figures 7 to 9) conL

I Z_ CAUTION: Bladesare verysharp.ALWAYShandle bladesvery

carefullyFailureto do so couldresult in possibleseriousinjury.

NOTE: DO NOT remove the blade clamp.This couldalter the factory setting

for cuttingheight and bladeheight.

NOTE: DO NOT adjust the height

adjusting screws.

6. Place new blade or reverse existing

blade into blade clamp.(See Fig. 9),

7. Check to be sure blade is properly

positioned in blade clamp and the

blade edge is level with the base.

(See Fig. 9).

8, Securely re-tighten the 3 bolts.

9, Repeat the steps 3 through 8 above

to change or reverse the other blade.

10. Remove piece of wood from planer.

Z_ Warning: ALWAYS remove the piece of woodbefore starting your J

planer.Failureto doso couldresult in the pieceof woodbeing thrownfrom

yourplaner, causingpossibleseriousinjury.

USING THE LEFT OR RIGHT DUST / CHIP

EXTRACTION (See Figure 10)

The dust / chip chute can be adjusted for

left or right extraction. Turn chute clockwise

for extraction on the left side, or turn it

counterclockwise for extraction on the right

side.The arrow on the top of the chute

indicates the direction the chips will be

extracted.