Owner`s manual

ADDmONAL RULES FOR SAFE OPERATION cont.
6. ALWAYS check for damaged parts. Before further use of the toot,
a guard or other part that is damaged should be carefully checked to
determine If it will operate properly and perform its intended function.
Check for misallgnment or binding of moving pads, breakage of parts,
and any other condition that may affect the tool's operation. A guard or
other part that is damaged should be properly repaired or replaced at
a Sears Service Center. Followingthis rulewillreduce the riskofa ectr c
shock,fire or seriousinjury.
7. DO NOT abuse the cord. NEVER use the cord to carry the tools or pull
the plug from the outlet. Keep cord away from heat, oil, sharp edges or
moving parts. Replace damaged cords immediately. Damaged cords
increasethe risk of eleCtriCshock. Followingthis rule will reducethe riskof
electricshock or fire.
8. ALWAYS make sure that your extension cord Is in good condition.
When using an extension cord be sure to use one that is heavy
enough to carry the current that your tool will draw. A wire gauge
(AWG) of at least 14 is recommendedforan extensioncord 25 feet or less
in length.When workingoutdoorsALWAYS use an extensioncord that is
suitablefor outdoor use.The cord'sjacket willbe marked WA.
Smatter gauge wires, have greater capacity (16 gauge wire has more
capacity than 18 gauge wire). An undersizedcord willcause a drop in
line voltage, resultingin lossof power and overheating.
9. ALWAYS inspect and remove all nails from lumber before planing,
Followingthis rulewill reduce the riskof seriouspersonal injury.
10. DO NOT use the tool while tired or under the Influence of drugs,
alcohol or any medication. Followingthis rule willreduce the riskof
electricshock, fire or serious persona_ iniury.
11. SAVE THESE INSTRUCTIONS. Refer to them frequently and use them
to instruct others who may use this tool. If someone borrows this tool,
make sure they have these instructions also.
6