Operator`s manual

TO REMOVE BLADE
See Figure5.
• Remove battery pack from saw.
WARNING: Failure to remove battery pack from
saw could result in accidental starting causing
possible serious pemonal injury.
• Removebladewrenchfrom storagearea. See Figure 1.
• Positionsaw as shown infigure 5, depress spindlelock
button, and remove blade screw.
Note; Turn blade screwclockwiseto remove.
• Removeouterbladewasher. See Figure4.
Note: Blade can be removed at this point.
DEPRESSSPINDLE
LOCKBLrrroN
LOOSEN
BLADE
SCREW
BLADE
WRENCH
LATCHES
BATTERYPACK
Fig. 6
BLADE GUARD SYSTEM
The lower blade guardattachedto your trimsaw isthere
for yourprotectionand safety.It should never be altered
for any mason. Ifit becomesdamaged or beginsto mtum
slow or sluggish,do notoperate yoursaw untilthe
damage has been repairedor replaced.Always leave
guardin operatingpositionwhen usingsaw.
DANGER: When sawing throughworkpieco,
lower bladeguarddoes notcover blade onthe
undersideofworkpiece.Since blade is exposedon
undersideofworkpiece,keep hands and fingers
away from cuttingarea. Any partof your bodycoming
in contact withmoving blade will resultin serious
injury.Sae Figure7.
LOWERBLADEGUARD
IS IN UP POSITION
WHEN MAKINGA CUT
TO
TIGHTEN
Fig. 5
TO INSTALL BA'I'rERY PACK
See Figure 6.
Note: Batterypack is shippedin a low charge condition.
Therefore, itmust be charged prior to use, Refer to page
10, "CHARGING BA'rFERY PACK" for charging
instructions.
• Place battery pack in your saw.Align raked rib on
batterypackwith groove insidesaw, then slidebattery
packin saw as shown in figure 6.
• Make surethe latches on each side ofyour b_ttery
pack snap intoplace and battery pack issecured in
saw before beginningoperation.
CAUTION: When placing battery pack in your
saw, be sure raised nb on battery pack aligns with
groove inside saw and latches snap into place
properly, Improper assembly can cause damage to
saw and battery pack,
BLADEEXPOSEDON
UNDERSIDEOFWORKPIECE
Fig. 7
Never use sew when guard Is not operating correctly.
Guard should be checked for correct operation before
each use. If you drop your saw, check the lower blade
guard and bumper for damage at all depth settings
before reuse. Note: The guard Is operallng correctly
when It moves freely and readily returns to the closed
position. If for any reason your lower blade guard
does not close freely, take Rto the nearest Sears Parts
and Repair Center for sarvloe before using.
12