Operator`s manual

• When making a cut use steady, even pressure,

Never force cuts.

• Do not cut warped or wet lumber.

• Always hold your saw firmly with both hands and keep

your body in a balanced position so as to resist the

forces of Idckback should it occur.

When using your saw, always stay alert and exercise

control. Do not remove your sew from workplece

while the blade Is moving.

DEPTH OF CUT ADJUSTMENT

Always keep correctblade depth setting.The correct

blade depthsetting for all cutsshould not exceed 1/4 inch

belowthe materialto be cut. More blade depth will

increasethe chance of kickbackand cause the cutto be

rough.One blade tooth below the materialto be cutworks

bestfor most efficientcuttingaction.

TO ADJUS'rBLADE DEPTH

• Remove battery packfrom saw.

WARNING: Failure to remove battery packfrom

saw couldresult in accidental startingcausing

possibleseriouspersonal injury.

STARTING A CUT

Know the dght way to use your saw,

See Rgure 13.

Never use your sew as shown In figure 14.

Fig, 13

TORAISE

SAW

BASE

ASSEMBLY

TO TO

LOWERSAW TIGHTEN

DEPTH

TO AI_USTIIIENT

LOOSEN KNOB Fig. 12

• Loosen depth adjustment knob. See Figure 12.

• Hold base flat against the workpiece and raise or lower

saw until the required depth is reached.

• "13ghtendepth adjustment knob securely.

WRONG Fig. 14

Never place your hand on the workpleoe behind your

sew while making a cuL

_. WARNING: To make sawing easierand safer,

alwaysmaintain proper controlof yoursaw. Lossof

controlofyour saw couldcause an accidentresulting

inposs_le,sedous injury.