Operator`s manual

POSITIVE 0° BEVEL STOP
See Figure23.
ADJUSTMENT
SCREW
REVEL
ADJUSTMENT
KNOB
• Turn screwand adjust base untilsquarewith saw
blade.
• "nghtenhax nutandbeveladjustmentknobsecurely.
"_ WARNING: Attemptingto make cutswithout
bevel adjustmentknob securely tightenedcon result
in sadous injury.
TO POCKET CUT
See Figure24.
HEX NUT
POSITIVE0°
BEVELSTOP
BLADE
WARNING: Always adjust bevel setting to zero
beforemeldng a pocket cut.Attemptinga pocketcutat
anyotharsettingcon resultin lossof contmlofyour
saw possiblycausingseriousinjury.
CARPENTER'S
SQUARE
Adjustthe bevel settingto zero, set bladeto correctblade
depthsetting,and swingthe lower blade guard up using
the lowerblade guard handle.
Always raise the lower blade guard wRh the handle to
avoid serious Injury.
While holdinglowerblade guard by the handle,firmlyrest
the frontof the baseflat against the workpiecowiththe
rear ofthe handle raised sothe blade does nottouchthe
workpiese.See Figure24.
Fig. 23
Yoursaw has a positiveO° bevel stop,that has been
factory adjusted to assure0° angle of your saw blade
when making90° cuts. However, misalignmentcon occur
duringshipping.
TO CHECK
• Remove battery pack from saw,
WARNING: Failure to remove battery pack from
saw couldresult in accidentalstartingcausing
possibleserious personalinjury.
• Place yoursaw in an upsidedown positionon
workbench. See Figure 23.
• Usinga carpenter'ssquare, check squarenessof saw
bladeto the base of your saw.
TO ADJUST
• Remove battery pack from saw.
WARNING: Failure to remove battery pack from
saw could resultin accidental startingcausing
possible serious personal injury.
• Loosenbevel adjustment knob.
• Loosenhex nut securingadjustmentscrew.
18
LOWERBLADE
GUARD HANDLE
POCKETCUT LOWERBLADEGUARD
Fig. 24
Depressthe lock-offbuttonand squeeze the switchtrigger
tostart yoursaw. Always let the blade reach full speed
then slowly lower blade Into the workplace until base
is flat against workpisce.
Afteryou complete yourcutreleasethe triggerand allowthe
bladeto come to a complete stop.Aftertheblade has
stopped,removeit fromthaworkpieco.Comers maythen be
clearedoutwitha hand saw orsabresaw,
WARNING: Never tie the lower blade guard in a
raisedposition. Leavingthe blade exposedcould
lead toseriousinjury,