Operator`s manual

TRIM SAW 315.114260
Blade Diameter 5-1/2 in.
Blade Arbor 3/8 in.
Cutting Depth at 0° 1-9/16 in,
Cutting Depth at 45° 1-1/8 in.
No load Speed 4,500 RPM
Motor 19.2 Volt DC
CHARGER
Input
ChargingVoltage
Charge Rate
BATrERY PACK
ITEM NO._9 11041
(1425301)
120 V, 60 Hz, AC only
19.2 Volt
1 Hours
ITEM NO. _ 11375
(1323517 and 1323903)
Yourtrim saw hasbeen shipped completelyassembled
exceptfor the blade. Inspectit carefullyto makesure no
breakageor damage has occurredduringshipping.Ifany
partsare damaged or missing, contactyour nearestSears
RetailStore to obtain replacementpartsbeforeattempting
to operate saw.Ablade, blade wrench (5 mm hexkey), rip
guide(edge guide)and this operator'smanual arealso
included.
WARNING: If anypartsare missing,do not
operateyoursaw untilthe missing partsare replaced.
Failureto do socould resultinpossiblessrious per-
sonaJinjury.
The following recommended accassones are currentlyavailableat Sears Retail Stores.
• 5-1/2 in.Thin Kerr Blade
WARNING: The useof attachmentsor accessoriesnotlisted mightbe hazardous.
KNOW YOU R TRIM SAW
See Figure 1.
Beforeattemptingto use yourtrim saw, familiarizeyoursoff
withall operatingfeatures and safety requirements.
Featuresincludeeasily operated bevel cut and depthof
cut adiustmentmechanisms;positive0° bevel stop;
spindlelock;and bladewrench storage.
" JkWARNING: Donotallow familiarity with your
saw to make you careless. Remember that a
carelessfraction ofa second is sufficientto inflict
severe injury.
SWITC H
Yoursaw is equippedwith a look-offbuttonwhichreduces
the possibilityof accidentalstarting.The lock-offbut'_onis
located on the handleabove the switchtrigger. Youmust
depressthe lock-offbuttoninorder to pullthe switch
trigger.The lock resets eaoh timethe trigger isreleased.
Nots: Youcan depress the lock-off buttonfrom eitherthe
leftor rightside:
APPLICATIONS
(Use only for the purposes listed below)
• Cuttingalltypes of woodproducts(lumber,plywood,
paneling).