Operator`s manual

_ WARNmNG:Beforeconnectingyourgrinderto
powersupply,alwayschecktobesureswitchis
notintockoonposition.Failuretodosocould
resultinaccidentalstartingofyourgrinder
resultinginpossibleseriousinjury.
ADJUSTINGGUARD
See Figures 4, 5, and 6,
The guard on your grinder should be correctly
installed depending on which side the handle is
mounted. Never use your grinder without the guard
correctly in pJace.
_ WARNING: Never place the guard so that it is
on front of the grinder as shown in Figure 6. This
could result in serious injury because sparks and
loose particles thrown from the grinding wheel
would be directed toward the operator. Always
place the guard in the correct location as shown.
Follow these directions when adjusting the guard.
[] Unplug your grinder.
,_ WARNING: Failure to unplug your grinder could
result in accidental starting causing serious
[] Loosen the clamp screw until you can remove the
guard from the bearing cap.
[] Rotate guard to its correct position as shown.
[] Tighten clamp screw securely.
NOTE: Be sure the raised ridge on the guard is
seated in the groove on the bearing cap. Never
use your grinder without the guard in place and
CORRECT
LOCATIONOF GUARD
(HANDLELEFT)
CORRECT
LOCATIONOFGUARD
(HANDLERIGHT)
Fig. 4
Fig. 5
11
INCORRECT__
LOCATIONOF GUARD 1
Fig. 6