Operator`s manual

2. Place your index finger between the two lines to stop

the lines from overlapping (see Fig. 32).

3. Wind both lines at the same time in even and tight

layers onto the reel, in the direction indicated on the

reel (Fig. 32).

NOTE: Failure to wind the lines in the direction indicated

will cause the cutting head to operate incorrectly.

4. insert one line end into each holding slot (Fig. 33).

Reinstalling the Reel

1. insert one line end through each of the eyelets in the

reel housing, and insert the reel and spring back into

the reel housing (Fig. 34).

2. Grasp the line ends and pull firmly to release them

from the holding slots in the reel.

3. Hold the reel in place and screw the Bump Knob TM

counterclockwise back onto the reel (see Fig. 29).

TO INSTALL A PREWOUND REEL

1. Hold the reel housing with one hand and unscrew

the Bump Knob clockwise (Fig. 29). Inspect the bolt

inside the Bump Knob to make sure it moves freely.

Replace the Bump Knob if damaged.

2. Remove the old reel from the reel housing (Fig. 29).

3. Remove the spring from the old reel (Fig. 29).

4. Use a clean cloth to clean the inner surface of the

reel housing (Fig. 39).

5. Place the spring in the new reel.

NOTE: The spring must be assembled on the reel before

reassembling the cutting attachment.

6. insert the ends of the line through the eyelets in the

reel housing (Fig. 34).

7. Place the new reel inside the reel housing. Push the

reel and reel housing together. While holding the reel

and reel housing, grasp the ends and pull firmly to

release the line from the holding slots in the reel.

8. Hold the reel in place and install the Bump Knob by

turning counterclockwise. Tighten securely.

Reel F--

Fig. 32

Fig. 33

Reel

Housing

Holding

Slots

Fig. 34

- 20 -