Instruction Manual CRAFTSMR 25cc/1.5 cu.in. 2-Cycle 205 MPH/410 CFM GASOLINE POWERED BLOWER/VAC Model No. 358.794981 • • Safety Assembly • ° Operation Maintenance • Parts List • EspaSol WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this product: Call 7 am-7 pm, Mon.-Sat., or 10 am-7 pm, Sun. 1-800-235-5878 Sears, 545082980 Roebuck 2/7/06 and Co., Hoffman _.
Warranty Statement Safety Rules Assembly Operation Maintenance Storage 2 2 4 6 9 11 Troubleshooting Table Emissions Statement Parts List Spanish Parts and Ordering 12 12 14 17 Back FULL TWO YEAR WARRANTY ON CRAFTSMAN® GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the instructions in the instruction manual, Sears will repair, free of charge, any defects in material or workmanship.
picked up by the air intake and thrown out through discharge opening, damaging unit, property, or causing serious injury to bystanders or operator. • Avoid dangerous environments. Do not use in unventilated areas or where explosive vapors or carbon monoxide build up could be present. • Do not overreach or use from unstable surfaces such as ladders, trees, steep slopes, rooftops, etc. Keep firm footing and balance at all times.
• Empty fuel tank before storing the unit. Use up fuel left in carburetor by starting engine and letting it run until it stops. • Do not use any accessory or attachment other than those recommended by manufacturer for use with your unit. • Do not store the unit or fuel in a closed area where fuel vapors can reach sparks or an open flame from hot water heaters, electric motors or switches, furnaces, etc. • Store in a dry area out of reach of children.
2. Secure thetubebyturning the knob clockwise. 3. Toremove thetube,turntheknob counterclockwise toloosen the tube;remove thetube. VACUUM ASSEMBLY VACUUM BAG ASSEMBLY 1. Open the zipper on the vacuum bag and insert the elbow tube. 2. Push the small end of the elbow tube through the smatI opening in the bag. Elbow Tube Small / Opening Latch _=[ .._ Blower Latch Area ..... A_ _._Outlet _s' Vacuum Inlet Cove 3.
3. Latch Area \ 4. 5. Extend your left arm toward the rear of the vacuum bag. Adjust shoulder strap until the vacuum bag/shoulder strap seam lies between your thumb and index finger. Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly. 3. 4. Remove the vacuum bag. Close the vacuum inlet cover and make sure it is latched closed. 5. Reinstall the blower tube (see BLOWER TUBE ASSEMBLY). SHOULDER STRAP ADJUSTMENT (for vaeuurn use only) 1.
THROTTLE LEVER The THROTqLE LEVER is used to select the desired engine speed and to stop the engine Move the throttle lever to the position for full speed operation. Move the throttle lever to the _ position for idle speed. To stop tile engine, move the throttle lever to the STOP position. the engine with fewer pulls on file starter rope. Activate primer button by pressing it and allowing it to return to its original position.
STARTING read and follow the safety rules relating to fuel before fueling your unit. IMPORTANT Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, empty the fuel system before storage for 30 days or longer.
8. Allow the unit to run for 30 more seconds at RUN before moving the throttle lever to the _ position. If the engine has not started after 5 pulis (at HALF CHOKE), repeat the STARTING A COLD ENGINE procedure. If the engine still does not start, proceed to STARTING A FLOODED ENGINE. g. To stop the engine, move the throttle lever to the STOP position. STARTING A WARM ENGINE NOTE: If fuel tank is empty, add fuel; then, follow STARTING A COLD ENGINE procedure. Do not fill fuel tank while engine is hot. 1.
• Throttle Lever - Ensure throttle lever functions properly by moving the throttle lever to the STOP position. Make sure engine stops; then restart engine and continue. • Fuel Tank - Do not use unit if fuel tank shows signs of damage or teaks. • Vacuum Bag - Do not use vacuum bag if it is torn or damaged. INSPECT AND CLEAN UNIT AND LABELS • After each use, inspect complete unit for loose or damaged parts. Clean the unit using a damp cloth with a mild detergent. • Wipe off unit with a clean dry cloth.
=& m_WARNING: Perform the following steps after each use: • Altow engine to cool, and secure the unit before storing or transporting, • Store unit and fuel in a welt ventilated area where fuel vapors cannot reach sparks or open flames from water heaters electric motors or switches, furnaces, etc. • Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury. • Store unit and fuel well out of the reach of children.
TROUBLESHOOTING TABLE (continued) TROUBLE REMEDY CAUSE Engine will not accelerate, lacks power, or dies under a load• Engine smokes excessively. Engine runs hot. j l. Clean or replace air filter. 12. Check for dirty fuel filter; replace. J Check for kinked or split fuel line; repair or replace. 3. Clean or replace spark plug and re-gap. 1. Air filter dirty. 2. Fuel not reaching carburetor. 3. Spark plug fouled• 4. Carburetor requires adjustment. 5. Carbon build up. 6. Compression low.
WHAT IS NOT COVERED: All failures caused by abuse, neglect, or improper maintenance are not covered. ADD-ON OR MODIFIED PARTS: The use of add-on or modified parts can be grounds for disallowing a warranty claim. Sears is not liable to cover failures of warranted parts caused by the use of add-on or modified parts. HOW TO FILE A CLAIM: If you have any questions regarding your warranty rights and responsibilities, you should contact your nearest authorized sen4ce center or call Sears at 1-800-469-4683.
Dectaraci6n de Garant_a Reglas de Seguridad Montaje Uso 17 17 20 22 Almacenaje Tabla Diagn6stica Declaraci6n de Emision Lista de Piezas Mantenimiento 26 Repuestos y Encargos 28 29 30 14 Contratapa GARANTIA DE DOS AI_IOS COMPLETOS PARA EL PROPULSOR DE AIRE A GASOLINA DE LA MARCA CRAFTSMAN® Durante dos (2) aSos a partir de la fecha de compra, siempre que se haga el mantenimiento, la lubricaci6n y los ajustes en este Propulsor de Aire a Gasolina segQn tas instrucciones de uso y mantenimiento en el manu
PIENSE ANTES DE PROCEDER • Use siempre protecci6n para los ojos al hacer uso, servicio o mantenimiento del aparato. El uso de protecion de ojos ayudar_t a prevenir la perdida de la vista y/u otras heridas graves, provocadas pot piedras o escombros que reboten en los ojos y en la cara al ser propulsados por et aparato. La protecci6n para tos ojos debe ser marcada Z87. • Use siempre protecci6n en los pies. No use el aparato descalzo ni con sandalias.
• • • • • • dras, tierra o ramas, hiriendo a personas o animales, rompiendo vidrieras o causando otros dafios. Nunca ponga el aparato en marcha sin toner todo el equipo correspondiente instalado. AI usar el aparato como propulsor de aire, sirmpre instale los tubos de propulsi6n. AI usar et equipo opcional de aspiraci6n, siempre instale los tubos y la bolsa de aspiraci6n. AsegQrese que la cremallera de ta bolsa de aspiraci6n se encuentre completamente cerrada.
ta Iocalidad donde usted se encuentra, entre en contacto con el Servicio de Sears para obtener et equipo de repuestos correspondiente. La rejilla anti- chispa, los tubos de propulsion y las boquillas deberan estar instalados en et aparato para estar en total cumplimiento con el regiamento. CONTENIDO DE LA CAJA Verifique que todos los artlculos siguiente lista esten incluidos: Modeto 358.794961 // :.
5. 6. Introduzca el tubo en forma de codo en la salida de aire del propulsi6n. AsegLirese de que la moldura del tubo en forma de codo este alineada con la ranura de salida de aire del propulsi6n. Gire ta perilla hacia la derecha para apretar el tubo en forma de codo. PIVOTE MONTAJE DEL TUBO DE ASPIRAClON 1. Alinee el tubo de aspiraci6n inferior como se ilustra. Introduzca el tubo de aspiraci6n inferior dentro del tubo de aspiraci6n superior. Tubo de aspiraci6n superior Tubo de aspiraci6n inferior 2.
4. 5. Ajuste la correa de hombro hasta que la costura entre ta bolsa de aspiraci6n y la correa quede entre et pulgar y el indice. AsegQrese de que el aire circule libremente desde el tubo en forma de codo hasta la bolsa. Si la botsa se encuentra torcide, el aparato no funcionara apropiadamente. CONOZCA $U PROPULSOR LEA EL MANUAL DE INSTRUCCIONES Y SUS REGLAS DE SEGURIDAD ANTES DE COMENZAR A USAR ESTE APARATO.
PALANCA DEL ACELERADOR La PALANCA DEL ACELERADOR se uso para seleccionar la velocidad deseada y para detener el motor. Mueva la patanca det aceterador a la posiciAn _' para maxima velocidad. Mueva la patanca det aceterador a la posiciAn -_ para conseguir ta marcha lenta. Para detener et motor, mueva la palanca del acelerador a la posiciAn STOP. BOMBEADOR El BOMBEADOR es usado para remover aire de el carburador y de las tlneas de combustible y tas Ilena de mezcla de combustible.
mezclar la gasolina con un aceite de sintetico de buena catidad para motores de 2 tiempos enffiados a aire. Recomendamos ei aceite de sintetico de la marca Craftsman. Mezcle ta AVISO: El aparato se debe poner de lado al agregar el combustible (vea la ilustracion abajo). gasolina con el aceite en la proporcion 40:1. Se obtiene una proporcion de 40:1 mezclando 3,2 onzas de aceite con cada gat6n de gasotina sin plomo. Se incluye con esta aparato un recipiente de 3,2 onzas de aceite.
marcha. Los escombros tales como gravilla, arena, tierra, cesped, etc., pueden ser succionados por la entrada de aire y arrojados por la salida de propulsi6n, dafiando et aparato u otros bienes o causando graves heridas a espectadores o al usuario. PARA ARRANCAR CON FRIO 1. Mueva la palanca del la posici6n 4j_. 2. Mueva la palanca del posicion FULL CHOKE. 3. Lentamente, presione bombeador 8 veces.
RESPONSABILIDAD DEL USUARIO ADVERTENCIA: Desconecte la bujla antes de reatizar mantenimiento, servicio, o ajustes.
Siempre limpie el fittro de aire despues ded cada 5 horas de uso. Limpieza del filtro det aire: 1. Limpie la cubierta y el Area contigua para evitar que caiga tierra en la c_tmara del carburador cuando remueva ta cubierta. 2. Retire las piezas como se ilustra. AVlSO: No limpie el filtro de aire con gasolina ni ning0n otro sotvente inflamable, ya que de hacerlo puede crear petigro de incendio y de emicioRes evaporativas nocivas. 3. Lave el filtro con agua y jab6n. 4. Permita que et filtro se seque. 5.
ADVERTENClA: Realice los siguientes pasos despu@s de cada uso: • Permita que el motor se enfde y fije bien el aparato antes de guardarlo o transpoltarlo. • Guarde el aparato y el combustible en un lugar bien ventitado donde los vapores de combustible no puedan entrar en contacto con chispas o llamas abiertas provenientes de termotanques, motores o interruptores electricos, calefactores centrales, etc.
TABLA DIAGNOSTICA ADVERTENCIA: de hacer cualquiera no requieran SINTOMA El motor no arranca. Siempre apague el aparato y desconecte la buj[a antes de las reparaciones recomendadas a continuaci6n que que la unidad este en o ,eraci6n, i CAUSA SOLUClON i 1. El motor esta ahogado. i2. i 3. i i 4-. El tanque est& vacio. de combustible La bujia no est& haciendo chisp& El combustible no est& Ilegando a_cerburedor. 5. La compresJ6n El motor no anda en marcha lenta como debe. esta bale.
SUS DERECHOS Y OBLIGACIONES DE GARANTtA: La Agencia de Protecci6n Ambiental de los Estados Unidos, la Junta de Recursos Ambientales de California y Sears, Roebuck and Co., U.S.A., se complacen en expticar la garantla con la que cuenta el sistema de control de emisi6n en su motor peque_io, modelo 2005 y m#,s adetante, para uso fuera de carretera.
COMO ENTABLAR UNA RECLAMACtON: Si cuenta usted con alguna pregunta retacionada con sus derechos y responsabilidades de garant[a, usted debera entrar en contacto con su centro de servicio autorizado m_.s cercano o Ilamar a Sears al 1-800-469-4663. DONDE OBTENER SERVlClO DE pare efectos de "reparaci6n o reemplazo si fuera necesario" deber_, garantizarse por un per_odo de dos afios.