Operator`s manual

12
• Assembleashorttarpstraptoreardoorusingone
1/4"x1-1/4"hexbolt,two1/4"atwashersandone
1/4"nylocknut.Assemblean"S"hookthroughloose
endofstrap.Seegure15.Repeatonothersideof
door.
• Assembledoortorearofcartbyrestingbottomof
door on door supports and pushing top of door in
against cross brace. Secure top of door using door
latchesoneachside.Seegure15.
• Hookboththetarpstrapsontothe1/4"x1"hexbolts
inthesidesofthecart.Seegure15.
• Attachtheengine/impellerhousingassemblytothe
upper holes in the angles welded to the tongue. Use
four5/16"x3/4"hexboltsand5/16"nylocknuts.
Tighten.Seegure16.
FIGURE 16
FIGURE 15
5/16"
NYLOCK
NUT
5/16" x 3/4"
HEX BOLT
WELDED
ANGLES
FRONT
TONGUE
FIGURE 17
• Assembletheelbowtotheimpellerhousingusingfour
5/16"x3/4"threadforminghexboltsandfournylon
washers. Push while turning to help start the bolts into
the un-threaded holes. Tighten.Seegure17.
• Tocentertheelbowwiththeopeninginthehardtop:
a. Push the vinyl boot back inside the opening.
b. Loosen by approximately 1/4 turn each, the four
 boltsthatyouassembledingure17.
c. Push against the elbow to center it with the sides
of the opening.
d. Retighten the four bolts that you loosened.
• Pullthevinylbootontotheendoftheelbow.
Center elbow between
sides of opening
Loosen (4) bolts
1/4 turn each
5/16" x 3/4"
HEX BOLT
(Thread Forming)
NYLON
WASHER
1/4" x 1-1/4" HEX BOLT
1/4" FLAT WASHER
1/4" NYLOCK NUT
TARP STRAP (SHORT)
DOOR
SUPPORTS
DOOR LATCH
1/4" FLAT
WASHER
"S" HOOK
1/4" x 1"
HEX BOLT