Operator`s manual

13
• Assemblethehoseadapter(nozzle)tothefrontof
the impeller housing and secure with the three knobs.
Make sure that the switch actuator bracket contacts
theswitchonthehousing.Seegure18.
FIGURE 21
FIGURE 19
• Placeahoseclampontooneendofhose.Pushhose
ontohoseadapter(nozzle).Tightenhoseclamponto
hose and hose adapter. Do not collapse hose adapter
whentighteningclamp.Seegure19
• Placethehosehangerrodintothehosehangerbracket
ontheimpellerhousingassembly.Seegure19.
• Loopthe25"tarpstrapunderthehose.Hooktothe
hosehangerrod.Seegure19.
FIGURE 18
HOSE ADAPTER
(NOZZLE)
KNOB
SWITCH
ACTUATOR
BRACKET
• Assemblethehitchplatetothetractorhitchif:
a. Your tractor has a square (straight) hitch frame,
to help prevent binding.
b. Your tractor has a lightweight hitch frame that
needs reinforcing for towing the Chip-N-Vac.
 Usea1/2"x1-1/4"hexbolt,a7/16"atwasheranda
1/2"nylocknut.Seegure21.
TRACTOR
HITCH FRAME
(SQUARE)
HITCH
PLATE
TRACTOR
HITCH FRAME
(TAPERED)
1/2" x 1-1/4"
HEX BOLT
7/16" FLAT WASHER
1/2" NYLOCK NUT
ATTACH
MOW-N-VAC
HERE
FIGURE 20
5/16" FLAT
WASHER
CHIPPER CHUTE
ASSEMBLY
5/16"
NYLOCK
NUT
25" TARP
STRAP
HOSE HANGER ROD
HOSE
CLAMP
HINT: Tip the cart bed back for easier access in the next
paragraph.
•. Attachthechipperchuteassemblytotheweldbolts
on the back side of the impeller housing using three
5/16"atwashersand5/16"Nylocknuts.Tighten.
Seegure20.
• Insertthetamperplugintotheendofthechipper
chute assembly.