Manual

• Turnthespreaderupsidedownasshowninfigure1.
CROSSOVER TUBE SHAFT
SUPPORT
PLATE
FIGURE 1
MIDDLE BOLT
HITCH ,
TUBE
SHAFT
SUPPORT
PLATE
CROSSOVER
TUBE
, /
/ /
/ / _l'7
"MIDDLE
/ LOCK NUT
1/4" x 1-3/4" 1/4" HEX
HEX BOLT LOCK NUT
HITCH BRACE HITCH BRACE
FIGURE 2
• Assemble the two hitch braces to the inside of the
hopper frame using a 1/4" x 1-3/4" hex bolt and
1/4" hex lock nut on each side. DO NOT TIGHTEN
YET. See figure 2.
• Remove the lock nut from the middle bolt in the
crossover tube and shaft support plate. Leave the
bolt in place. See figure 2.
• Assemble the hitch tube onto the middle bolt and
secure it with the same lock nut you removed. DO
NOT TIGHTEN YET. See figure 2.
IMPORTANT: The hitch tube must attach to the side of
the crossover tube opposite the shaft support plate.
• Assemble the two hitch braces to the hitch tube using
a 1/4" x 1-3/4" hex bolt and a 1/4" hex lock nut. DO
NOT TIGHTEN YET. See figure 2.
Tighten the nuts and bolts fastening the hitch braces
to the hopper frame and the hitch tube, then tighten
the middle lock nut fastening the hitch tube to the
crossover tube. DO NOT COLLAPSE TUBES
WHEN TIGHTENING.
Assemble a spacer, a 1-5/8" flat washer, a wheel (air
valve facing out) and another 1-5/8" flat washer onto
the end of the axle that has only the small hole. See
figure 3.
Install a 1/8" x 1-1/2" cotter pin into hole in the axle.
See figure 3.
SMALL HOLE
AIR VALVE
1/8" x 1-112"
COTTER PIN
SPACER
1-5/8"DIA.
FLAT WASHER
FIGURE 3