User guide
OPERATIO
J
HOW TO USE YOUR CLEANING SYSTEM
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-80B-Z22-3136.
Pressure Washer Locatiii
Pressure Washer Clearance
A WARNING
M
Exhaust
heat/gases
can
ignite
combustibles,
structures or
damage fuel
tank
causing
a fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of
pressure
washer including
overhead.
Place pressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust
gas (A) could
accumulate and enter
inside or be drawn into a potentially occupied
building.
Ensure
exhaust
gas is kept away from any
windows,
doors,
ventilation
intakes, or other
openings
that can
allow
exhaust
gas to collect in a confined area.
Prevailing
winds and air
currents
should
be taken into consideration when
positioning
pressure washer.
A WARNING
»
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause headache,
fatigue, dizziness, vomiting, confusion, seizures,
nausea, fainting
or death.
Operate
pressure
washer
ONLY
outdoors.
Keep
exhaust
gas from entering a confined area through
windows, doors, ventilation intakes, or other openings.
DO NOT start or run engine indoors or in an enclosed area,
even if windows and doors are open.
To Start Your Cleaning System
To start your engine-powered cleaning system for the first
time, follow these instructions step-by-step. This information
also applies whenever you start the engine after you have let
the pressure washer sit idle for at least a day.
1
. Place
pressure washer outside near an water source
capable
of supplying
water
at a
flow
rate greater than
3.2 gallons per minute and no
less
than 20 PS! at
pressure washer end
of
garden hose.
2. Check that high pressure hose is
tightly
connected to
spray gun
and pump. See
Assemby
for
illustrations.
3. Make sure unit is in a
level
position.
4. Connect
garden
hose to water inlet on pressure washer
pump.
5. Turn ON water, point
gun
in a
safe
direction and squeeze
trigger to purge pump system of air and
impurities.
NOTICE
DO NOT run the pump without the water
supply
connected
and turned on.
Damage
to equipment
resulting
from failure to
follow
this
instruction will void
warranty.
Place colored
quick
connect
spray tips
in
slots
on
holder
that’s attached to nozzle extension.
7. Attach nozzle
extension
to spray
gun.
Tighten by hand.
8. Choose spray tip you want to use and insert it into
nozzle extension. See
How to Use Spray Tips.
9.
Engage trigger lock (A)
on spray
gun trigger.
11