User guide
I
SPECIFICATIONS
EieiiE TECHilCIL liFORMATIOi
This is a
single
cylinder. L-head, air cooled
engine.
It is a low
emissions engine.
In
the State of California, Model 120000 engines are certified
by the California Air Resources Board to meet emissions
standards for 125 hours. Such certification does not grant
the purchaser, owner or operator of this engine any
additional warranties with respect to the performance or
operational
life
of this
engine.
The engine is warranted
solely
according to
the
product and emissions warranties stated
elsewhere in this
manual.
Power Ratings
The gross power rating for individual
gas
engine models is
labeled
in accordance with SAE (Society of Automotive
Engineers) code J1940
(Small
Engine Power & Torque
Rating
Procedure), and
rating
performance has been
obtained and corrected
in
accordance with SAE J1995
(Revision 2002-05). Torque values are derived at 3060 RPM;
horsepower
values
are derived at 3600 RPM. Actual
gross
engine power
will
be
lower
and is affected by,
among
other
things, ambient operating conditions and engine-to-engine
variability.
Given
both
the wide array of products on which
engines are placed and
the
variety of
environmental
issues
applicable to operating the equipment, the
gas
engine will not
develop the rated
gross
power when used in a
given
piece of
power equipment
(actual
"on-site" or net power). This
difference is due to a
variety
of factors
including,
but not
limited to, accessories (air cleaner,
exhaust,
charging,
cooling,
carburetor,
fuel pump,
etc.),
application
limitations,
ambient operating conditions (temperature, humidity,
altitude), and engine-to-engine
variability.
Due to
manufacturing and capacity limitations,
Briggs
& Stratton
may
substitute
an
engine
of higher rated power for this
Series
engine.
PRODUCT SPECIFICATIONS
Pressure Washer Specifications
Max
Outlet
Pressure............................................ 2,550 PSi
Max
Flow
Rate
...................................................
2.3 GPM
Chemical Mix................................................Use as directed
Water Supply Temperature
.....................
Motto exceed 100°F
Shipping Weight
......................................................
72 lbs.
Engine Specifications
Bore................................. 2.69 in. (68mm)
Stroke ....................................................... 2.04 in. (52mm)
Displacement ............................................ 11.57 in. (190 cc)
Spark Plug
Type:
......................
Briggs & Stratton 802592 or 5095D
Set Gap To:
......................................
O.OSOinch (0.76mm)
Armature Air Gap:
....................
0.006-0.010 in.(0.15-0.25mm)
Valve clearance with valve springs installed and piston 1/4 in.
(6 mm) past top dead center (check when engine is cold).
Intake
..................................
0.005-0.007 in.(0.13-0.18 mm)
Exhaust
...............................
0.007-0.009 in.(0.18-0.23 mm)
Fuel Capacity..................................................... 1.6 Quarts
Oil Capacity
.........................................
18 Ounces (0.5 liter)
NOTE:
For practical operation, the engine
load
should
not
exceed 85% of rated power. Engine power
will
decrease
3-1/2% for each 1,000 feet (300 meters)
above
sea level and
1
% for
each 1
0“ F (5.6°
C) above
77°
F
(25°
C). It should
operate satisfactorily at an angle up to 15°.
15