User guide

EiGliE MAIiTEiAiCE
A WARiliG
Ü
Unintentional sparking can result in fire or
electric shock.
WHEi ABJUSTIIG OR MMiiG REPAIRS TO YOUR
PRESSURE WISHER
• Disconnect the spark plug wire from the spark plug and place
the wire where it cannot contact spark plug.
WHEi TESTiiG FOR EiGIIE SPflRi
• Use approved spark plug tester.
• DO NOTcheck for spark with spark plug removed.
Oil
Oil Recommeiilatioiis
NOTE: Use a high quality detergent oil classified “For Service
SF, SG. SH. SJ” or higher. DO NOT use special additives.
1. Choose a viscosity according to the table below:
. 104 F
86
68
50
32
14
4
r' -22
o
40 C
30
20
10
0
-10
-20
-30
NOTE: Synthetic oil meeting ILSAC GF-2, API certification
mark and API service symbol with “SJ/CF ENERGY
CONSERVING” or higher, is an acceptable oil at all
temperatures. Use of synthetic oil does not alter required oil
change intervals.
SAE 3i: 40°Fand higher (5°C and higher) is good for all
purpose use above 40°F, use below 40°F will cause hard
starting.
10W-30: 0 to 100°F (-18 to 38°C) is better for varying
temperature conditions. This viscosity improves cold weather
starting, but may increase oil consumption above 80“F
(27“C).
* Check oil level frequently at higher temperatures.
Synthetic 5W-3Ì: -20 to 120°F (-30 to 40 provides the
best protection at all temperatures as well as improved
starting with less oil consumption.
5W-30: 40°Fand below (5°C and below) is recommended for
winter use and works best in cold conditions.
Oil level should be checked prior to each use or at least every
5 hours of operation. Keep oil level maintained.
Checking Oil Lewel
Make sure pressure washer is on a level surface.
Remove oil dipstick and wipe dipstick with clean cloth.
Replace and tighten dipstick. Remove and and check oil
level.
Verify oil is at “Fyll” mark on dipstick. Replace and
tighten dipstick.
Adding Engine Oil
1. Make sure pressure washer is on a level surface.
2. Check oil level as described in Checking Oil Level.
3. If needed, slowly pour oil into oil fill opening to the
“Full” mark on dipstick. DO NOT overfill.
iOTiCE
Overfilling with oil may cause the engine to not start, or
hard starting.
DO NOT overfill.
If over the FULL mark on dipstick, drain oil to reduce oil level to
FULL mark on dipstick.
4. Replace and tighten dipstick.
Changiig Engine Oil
Change engine oil after the first 5 hours and every 50 hours
thereafter. If you are using your pressure washer under
extremely dirty or dusty conditions, or in extremely hot
weather, change oil more often.
CiUTIOi
Avoid prolonged or repeated skin contact with used motor
oil.
Used motor oil has been shown to cause skin cancer in certain
laboratory animals.
Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OE CHILDREN. DONT
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
Change oil while engine is still warm from running, as
follows:
1 . Drain fuel tank by running pressure washer until fuel
tank is empty.
2. Disconnect spark plug wire and keep it away from spark
plug.
18