User guide
5.
Insert spray
gun holder wi
reform
(A)
through
hole just
above cleaning tank on left side of handle (viewing from
front
of
unit). Hold wi reform in
place
and attach a plastic
knob (B) from inside of unit. Tighten by hand.
«taci ietergeni Siphon Hose to Pimp
The pressure washer is equipped with two detergent
siphoning hoses. One is attached to the cleaning tank and
one is loose for siphoning pressure washer safe detergents
from a bottle or container.
Attach one of the detergent siphon hoses
(A)
to the barbed
hose fitting (B)
on the pump.
/ j I
IMPORTANT: Only
one detergent siphoning hose can
be
used
at
a time. When
cleaning
tank is not used, make sure
detergent shut-off
valve
on cleaning tank is in the
“Off
position.
Add Engine Oil
1
. Place
pressure washer on a flat,
level
surface.
2. Clean area around oil
fill
and remove
yellow oil fill
cap/dipstick.
NOTE:
See
Oil Recommendations
in
Maintenance
section.
Verify
provided
oil bottle
is the correct viscosity for current
ambient
temperature.
3. Using oil funnel (optional), slowly pour contents of
provided oil
bottle
into oil fill opening.
iOTiCE
Improper treatment of pressure washer can damage
it
and
shorten
its life.
___________
_
______________
_
______
• DO NOT
attempt
to
crank
or
start the
engine before it has
been
properly
serviced
with
the
recommended oil. This may result in
an
engine failure.
Mi
Fuel
Fuel must meet these requirements:
• Clean, fresh, unleaded gasoline.
» A minimum of 87 octane/87 AKI (91 ROM). High altitude
use,
see
High Altitude.
• Gasoline with up to 10% ethanol (gasohol) or up to 15%
MTBE (methyl tertiary
butyl
ether) is
acceptable.
NOTICE
Avoid pressure washer damage.
Failure to follow Operator’s Manual for fuel
recommendations
voids
warranty.__________
DO
NOT
use unapproved
gasoline
such as E85.
DO NOT mix oil in gasoline.
DO NOT modify engine to run on alternate fuels.
0
protect the
fuel
system from
gum
formation, mix in a
fuel
stabilizer
when
adding
fuel. See Storage.
All fuel is
not the
same.
If
you experience starting or performance problems
after
using fuel,
switch to a different
fuel
provider or change
brands. This engine
is
certified to operate on
gasoline.
The
emission control system for this engine is EM (Engine
Modifications).
A WARNING
M
Hi
Fuel
and
its vapors are extremely flammable and
explosive.
Fire or
explosion
can cause severe burns or
death.
WHEN IDDING FUEL
• Turn pressure washer OFF and let it cool at least 2 minutes
before
removing fuel
cap. Loosen cap slowly to
relieve
pressure
in tank.
• Fill fuel
tank outdoors.
• DO
NOT
overfill
tank.
Allow
space
for fuel
expansion.
• if fuel spills, wait until it evaporates before starting engine.
• Keep fuel away
from
sparks, open flames, pilot lights,
heat,
and
other
ignition
sources.
• DO NOT light a cigarette or
smoke.
1. Clean area around fuel fill cap, remove cap.
2. Slowly add regular unleaded fuel (A) to fuel tank (B)
Be
careful not to overfill. Allow about 1.5" (4 cm) (C) of tank
space for
fuel
expansion.
4. Replace
oil fill cap/dipstick
and
fully
tighten.
3.
Install fuel
cap and wait for any spilled
fuel
to evaporate.