Manual

PRODUCT SPECIFICATIONS
Generator Specifications
Rated Maximum Power
Rated Voltage
Rated Maximum
Load Current
Rate Frequency
Phase
2500 (2.5 KW)
12 VDC and 120 Volts AC
20.8 AC amperes
60 Hz at 3600 rpm
Single Phase
Engine Specifications
Rated Horsepower 5,0 at 3600 rpm
Spark Plug NGK BPR6ES
or equivalent
Set Gap To: 0.030 inch (0.76mm)
Gasoline Capacity: 1.8 quarts
Oil (Q.61 US quarls capacity): SAE 30 weight
Solid State Ignition 0.0125 inch
Air Gap
Should you experience any problem you cannot easily
remedy, please contact your nearest Sears Service Cen-
terJDepartment or call the 1-800 number listed on the
front of this manuat we have competent, well-trained
technicians and the proper toolsto service or repair' this
unit,.
Please read and retain tn_smanual, the instructions will
enable you to assemble and maintain your' generator
properly. Always observe the "SAFETY RULES'L
Once a year you should clean or' replace the spark plug
and replace the air filter A new spark plug and clean air
filter assure proper fuel-air mixture and help your engine
run better and last longer
MAINTENANCE AGREEMENT
A Sears Maintenance Agreement is available on this
product,,
CUSTOMER RESPONSIBILITIES
Read and observe the safety rules.
Follow regular schedule in maintaining, caring for and
using your generator.
Follow the instructions under "Maintenance" and "Stor-
age" sections of this Owner's Manual.
NOTE: Your generator is equipped with a spark arrestor
muffler: The spark arrestor must be maintained in effec-
tive working order by the owner/operator_ In the State of
California a spark arrestor is required by law (Section
4442 of the California Public Resources Code)_ Other
states may have similar' laws. Federal laws apply on fed-
eral lands°
CAUTION:DISCONNECTSPARKPLUGWIRE
FROMSPARKPLUGANDPLACEWIRE WHEREIT
CANNOT'COMEIN CONTACIWITHYOURSPARK
PLUGBEFOREWORKINGON YOURGENERATOR.
GENERATOR MAINTENANCE
Generator maintenance consists of keeping the unit clean
and dry Operate and store the unit in a clean, dry envi-
ronment where it wilt not be exposed to excessive dust,
dirt, moisture or any corrosive vapors,, Cooling air slots in
the generator must not become clogged with snow,
leaves, or any other foreign material.
Check the cleanliness of the generator frequently and
clean when dust, dirt, oi!, moisture or other foreign sub-
stances are visible on itsexterior surface,.
Note: We DO NOT recommend using a garden hose to
clean the generator_ Water can enter-the engine fuel sys-
tem and cause problems,, tn addition, ff water enters the
generator through cooling air slots, some of the water will
be retained in void and cracks of the rotor and stator
winding insulation, Water and dirt buildup on the genera-
tor internal windings will eventually decrease the insula-
tion resistance of these windings°
To clean the Generator:
* Use a damp cloth to wipe exterior surfaces cfean.
° A soft bristle brush may be used to loosen caked on
dirt, oil, etc.
. A vacuum cleaner may be used to pick up loose dirt
and debris.
° Low pressure air (not to exceed 25 psi) may be used
to blow away dirt,, inspect cooling air' slots and open-
ings on the generator,, These openings must be kept
clean and unobstructed.
CAUTION:NEVERINSERTANY OBJECTORTOOL1
THROUGHTHE AIR COOLINGSLOTS,EVENIF !
THE ENGINEIS NOTRUNNING. DAMAGETO THEi
UNITORPERSONALINJURYMAYRESULT. J
10