Operator`s manual
_NOWYOUR SCREWDRIVER
See Figure 1.
_efore attempting to use your screwdriver, familiarize
fourself with all operating features and safety
_equirements.
I_ WARNING: Carefully readthroughthis entire
operator'smanualbeforeusingyournewscrewdriver.
Pay close attention to the Rules For Safe Operation,
: Wamings and Cautions. Ifyou use your screwdriver
i properly and only for what it is intended, you will enjoy
years of safe, reliable service.
i_1 WARNING: If any parts are missing, do not operate
your screwdriver untilthe missing parts are replaced.
Failure to do so could result in possible serious
personal injury.
SWITCH
Your screwdriver is equipped with a rocker type switch
which turns your screwddver ON and OFF. This switch
:lisa controls the forward and reverse feature. For driving
ycrews, depress right side of switch. For removing screws,
_epress left side of switch.
,_ WARNING: Do not allow familiarity with screw-
your
driver to make you careless. Remember that a careless
fraction of a second is sufficient to inflictsevere injury.
PRODUCT SPECIFICATIONS"
SCREWDRIVER
Collet
Motor
Switch
No Load Speed
Maximum Torque
CHARGER
Charger Rating
Charger Voltage
Charger Rate
973.112090
1/4 in.
2.4 Volt DC
Single Speed / Reversible
150 RPM
30 in./Ibs
Part No. 7221801
120 Volts, 60 Hz, AC only
2.4 Volt
3 - 5 Hours
SWITCH(ON/ OFF)
(FORWARD/ REVERSE)
FORWARD
INPUT
JACK
TORQUE
ADJUSTMENTCAP
\
COLLET
REVERSE
Fig. 1
7