Operator`s manual

REVERSIBLE KEYLESS CHUCK
See Figure 5.
This tool has the feature of being reversible. The direction
of rotation is controlled by a selector located above the
switch trigger. With the drill-driver held in normal
operating position, the direction of rotation selector should
be positioned to the left of the switch for drilling. The
drilling direction is reversed .when the selector is to the
right of the switch. When the selector is in center position,
the switch trigger is locked.
See Figure 6.
Your drill-driver has a keyless chuck. As the name implies,
you can hand tighten or release drill bits in the chuck jaws.
Grasp and hold,the collar of the chuck with one hand.
Rolate the chuck body with your other hand. The arrows on
the chuck indicate Which direction to rotate the chuck body
in order to LOCK (tighten) or UNLOCK (release) the drill bit.
UNLOCK CHUCK
(RELEASE) COLLAR
FORWARD REVERSE
CENTERPOSITION
(LOCK)
TRIGGER
DIRECTIONOF
ROTATIONSELECTOR
(FORWARD/REVERSE)
Fig. 5
,_ CAUTION: To prevent gear damage, always allow
chuck to come to a complete stop before changing
the direction of rotation.
TO STOP
To stop, release switch trigger and allow the chuck to
come to a complete stop.
SWITCH LOCK
See Figure 5.
The switch trigger can be locked in the OFF position. This
feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch trigger,
place the direction of rotation selector in center position.
DRILLBIT
LOCK
(TIGHTEN)
CHUCK
BODY
Fig. 6
_lb WARNING: Do not hold chuck body with one hand
and use power of the drill-driver to tighten chuck
jaws on drill bits. Chuck body could slip in your hand
or your hand could slip and come in contact with
rotating drill bit. This could cause an accident
resulting in serious personal injury.
_ WARNING: Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
11