Operator`s manual

_ WARNING: Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
d_b, WARNING: Do not allow familiarity with your drill-
driver to make you careless. Remember that a
careless fraction of a se&ond is sufficient to inflict
severe injury.
CHARGING BATTERY PACK
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems, Therefore,
you should charge it overnight prior to use.
Note: Batteries will not reach full charge_the first time they
are charged. Allow several cycles (drillin0,followed by
recharging) for them to become fully charged.
TO CHARGE
• Charge battery pack only with the charger and charg-
ing stand provided.
• Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
• Connect charger to power supply.
• Place battery pack in charging stand. Align raised rib
on battery pack with groove in charging stand. See
Figure2.
• Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charging
Stand.
• When properly connected, the red light on charging
stand will turn on.
• Not_: If charger does not charge battery pack, return
battery pack, charger and charging stand to your nearest
Sears Repair Center for electrical check.
• After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack. Note: If battery
pack is completely discharged, 6 hours or longer of
charging time is required to fully recharge battery pack.
• The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
• Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
• When batteries become fully charged, unplug charger
from power supply.
BATTERY
PACK
CHARGING
STAND
CHARGER
RED
LIGHT
Fig. 2