Operator`s manual

OPERATING THE CONVERTIBLE TM COUPLER SYSTEM
__J WARNING: To avoid serious personal injury and I
I
damage to the unit, shut the unit off before removing or
]
installing attachment.
NOTE: To make installing or removing the attachment easier, place
the unit on the ground or on a work bench.
installing the Trimmer Attachment or Other Attachment
NOTE: Remove the protective cap and gray spacer from the upper
and lower shafts prior to assembling the attachment.
1. Turn the knob counterclockwise to loosen (Fig. 3).
2. While firmly holding the trimmer attachment or other attachment,
push it straight into the Convertible TM coupler until the release
button snaps firmly into the primary hole (Fig. 5).
NOTE: Aligning the release button with the guide recess will help
installation (Fig. 4).
3. Turn the knob clockwise to tighten (Fig. 3).
_ CAUTION: Before operating this unit, be sure that the
|
release button is fully snapped into the primary hole (Fig. 5),
1
and that the knob (Fig. 3) is securely tightened.
For decorative edging with the line head trimmer attachment, lock
the release button of the attachment into the 90° hole (Fig. 3).
Removing the Trimmer Attachment or Other Attachment
1. Turn the knob counterclockwise to loosen (Fig. 3).
2. Press and hold the release button (Fig. 4).
3. While firmly holding the upper shaft housing, pull the trimmer
attachment or other attachment straight out of the Convertible TM
coupler (Fig. 5).
The Convertible TM Coupler System
The Convertible TM coupler system enables the use of these optional
attachments.
• Edger
Cultivator
Turbo Blower
Brushcutter
Pole Saw
Hedge Trimmer
Straight-shaft trimmer
Curved-shaft trimmer
_ WARNING; Before you begin using any attachment,
i
read and understand the manual that came with the
1
attachment. Follow all safety information contained within.
_ CAUTION: These attachments are to be snapped into 1
the primary hole only. Using the wrong hole could lead to
personal injury or damage to the unit.
90° Edging Hole
(Trimmer Only)
Fig. 3
Knob
Convertible TM
Release Button
Coupler
Guide Recess
Fig. 4
Primary Hole
Upper Shaft
Lower Shaft
Housing Housing
Fig. 5