About the Crate Acoustic CA112D: D esigned for the performing artist, Crate’s CA112D Acoustic Amplifier gives you more of what you want. More power. More clarity. More control. And, more freedom. Imagine: microphone quality sound, without feedback. And without being “chained” to a mic stand! More power: twin 50-watt RMS power amplifiers drive a specially designed dual voice coil 12” low frequency transducer for plenty of volume and low end punch.
Crate Acoustic amplifiers are Made With Pride in the U.S.A. To get this amplifier to sound its best, read this owner’s guide prior to its use. Technical Specifications: Output Power Rating: 125 watts RMS total system power Woofer Amp: 2 x 50 watts RMS @1% THD Tweeter Amp: 25 watts RMS @1% THD To keep this amplifier looking its best, avoid abrasive cleansers. Wipe the cabinet clean using a slightly dampened cloth. Never use brass cleaners on the hardware since they could damage their protective coatings.
On the Front Panel: 1 2 3 4 5 6 7 Low Mid 0 0 8 9 10 11 High Freq Cut Rev/Eff Send 0 500Hz –15dB Instrument Gain Input Contour 175 12 13 14 Chorus Depth Master Rate 1.2k Graphic Eq On Piezo Power +12dB 0 10 –15 +15 –15 +15 500Hz 1.
On the Rear Panel: The DSP Section: 35 34 33 Tweeter 32 31 30 27 28 The CA112D features Crate’s On-Board Digital Signal Processing (DSP) technology that was designed specifically for use with acoustic instruments and vocals. This provides a large selection of digital reverbs, effects and delays. Select the type of effect desired by rotating the Mode control (#22).
www.crateamps.com ©1999 SLM Electronics A Division of St. Louis Music Co. 1400 Ferguson Avenue St.