Owner`s manual

V5 Tube Guitar Amplifier
5
The Rear Panel
6. AC LINE CORD: The grounded power
cord should only be plugged into a
grounded power outlet that meets
all applicable electrical codes, and is
compatible with the voltage, power, and
frequency requirements stated on the
V5 rear panel. Do not attempt to defeat
the safety ground connection.
7. FUSE: This protects the unit from
damage due to overload conditions or
power line surges. If the fuse blows,
replace it only with the same size and
type as listed on the chassis.
8. Voltage Select Switch: Set this switch
to “115” for 120 VAC mains, and to
“230” for 220-240 VAC mains.
With the amplifier power cord
unplugged, use the tip of a small flat-
blade screwdriver to slide this switch to
the proper position.
9. SPEAKER 8 OHMS: The V5 is shipped
with a cable connected from this jack to
the internal 10-inch 8-ohm speaker.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
USC
3031613
CONFORMS TO
IEC 60065
~100-240V
50-60 Hz 30W
N222
ROHS
SERIAL NUMBER
MANUFACTURING DATE
AVI S: RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER. NO
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
c 2007 LOUD TECHNOLOGIES INC
DESIGNED IN ST.LOUIS MO, USA. MANUFACTURED IN CHINA, FABRIQUE EN CHINE
SPEAKER
8 Ohms
115
6
7 8 9