Instructions / Assembly

SAVE THESE INSTRUCTIONS

ASSEMBLE ON A FLAT, PROTECTED SURFACE.

PART LIST FIGURE QUANTITY DESCRIPTION

A 1 PC BACK

B 1 PC RIGHT ARM

C 1 PC LEFT ARM

D 1 PC SEAT

E 2 PCS GLIDER

F 1 PC RIGHT LEG

G 1 PC LEFT LEG

H 2 PCS LEG SUPPORT

I 2 + 1 PCS LONG BOLT (M6*40)

J 14 + 1 PCS MEDIUM BOLT (M6*30)

K 8 + 1 PCS SHORT BOLT (M6*15)

L 24 + 1 PCS FLAT WASHER

M 1 PC ALLEN WRENCH

Page

1/3

PAGE 1
SAVE THESE INSTRUCTIONS ASSEMBLE ON A FLAT, PROTECTED SURFACE.
PAGE 2
ASSEMBLY INSTRUCTIONS (CONTINUED) STEP 1 A. PLACE RIGHT ARM (B) UPSIDE DOWN ON A FLAT, PROTECTED SURFACE. B. ATTACH BACK (A) TO RIGHT ARM (B) USING FLAT WASHER (L) AND MEDIUM BOLT (J). LOOSELY TIGHTEN WITH ALLEN WRENCH (M). STEP 2 A. PLACE LEFT ARM (C) UPSIDE DOWN ON A FLAT, PROTECTED SURFACE. B. ATTACH BACK (A) TO LEFT ARM (C) USING FLAT WASHER (L) AND MEDIUM BOLT (J). LOOSELY TIGHTEN WITH ALLEN WRENCH (M). STEP 3 A. PLACE ASSEMBLY FACE DOWN ON A FLAT, PROTECTED SURFACE AS SHOWN. B.
PAGE 3
ASSEMBLY INSTRUCTIONS (CONTINUED) STEP 5 A. CONNECT THE TOPS OF GLIDERS (E) TO THE TOP OF RIGHT LEG (F) AND LEFT LEG (G) USING FLAT WASHER (L) AND MEDIUM BOLT (J). LOOSELY TIGHTEN WITH ALLEN WRENCH (M). STEP 6 A. ATTACH THE LEG SUPPORTS (H) TO THE BOTTOMS OF RIGHT LEG (F) AND LEFT LEG (G) USING FLAT WASHER (L) AND SHORT BOLT (K). LOOSELY TIGHTEN WITH ALLEN WRENCH (M). DO NOT TIGHTEN COMPLETELY. STEP 7 A. ROTATE BENCH TO UPRIGHT POSITION. B. FULLY TIGHTEN ALL BOLTS WITH ALLEN WRENCH (M). C.