Cut Sheet

T-Force® Degreaser Revolutionary Technology Degreaser
DISCLAIMER: This information is accurate to the best of CRC Industries’ knowledge or obtained from sources believed by CRC to be
accurate. Before using any product, read all warnings and directions on the label. All products should be tested for suitability on a particular
application prior to actual use. CRC Industries, Inc. makes no representations or warranties of any kind concerning this data.
CRC Industries, Inc. Industrial Products Division Warminster, PA 18974
Technical Service: [phone] Customer Service: [phone] CRC On-Line: [phone]
Literature Reorder #TDS309 CRC On-Line #309 REV. 10/12
VI. Performance Characteristics
ASTM D-1130 (KB Value)
97
ASTM D-877 (Dielectric Strength)
39,000 volts
VII. Directions
 For personal safety, do not use while equipment is energized.
 Remove mechanical plates, covers, etc. to expose equipment interior.
 For best results, remove heavy deposits of contaminants by scraping with a knife or wire brush.
 Spray liberally and allow to run off.
 Use extension tube for hard-to-reach areas.
 Allow equipment to fully dry and vent before using.
 Do not use on modern plastics such as LEXAN, ABS and Noryl. If uncertain, check with the
manufacturer or test on a small area before using.
 Not for use on sensitive electronics, computers, tape decks or VCRs. Use a CRC precision cleaner
instead.
VIII. Package Description
Part Number Container Size
03115 20 oz Aerosol
03116 1 Gallon
03117 5 Gallon
03118 55 Gallon
IX. Disposal
Disposal requirements vary by state and local jurisdiction. All used and unused product should be disposed of in
conformance with local, state and federal regulations.
X. Special Use Warnings
Aerosol Cans
Do not puncture, incinerate or store above 120F. Exposure to high temperatures may cause can to burst. Do not
place in direct sunlight or near any heat source. Aerosol cans will conduct electricity. Keep away from all live
electrical sources including battery terminals, solenoids, electrical panels and other electronic components. Failure to
observe this warning may result in serious injury from flash fire and/or electrical shock.
General
Use only in well ventilated area. Ventilation may be improved by opening a window or door or providing mechanical
assistance. Avoid continuous breathing of vapor and spray mist. Avoid contact with skin and eyes. If ventilation is
not adequate, respiratory protection should be worn. For more information regarding short term and long term
exposure, review this product’s Material Safety Data Sheet.