MSDS

SAFETY DATA SHEET
1. Identification
Product identifier Battery Terminal Protector
Other means of identification
Product code
05046, 05646, 05746
Recommended use
Battery terminal protector
Recommended restrictions
None known.
Manufacturer/Importer/Supplier/Distributor information
Manufactured or sold by:
Company name
CRC Industries, Inc.
Address
885 Louis Dr.
Warminster, PA 18974 US
Telephone
General Information
215-674-4300
Technical
Assistance
800-521-3168
Customer Service
800-272-4620
24-Hour Emergency
800-424-9300 (US)
(CHEMTREC)
703-527-3887 (International)
Website
www.crcindustries.com
2. Hazard(s) identification
Category 1Flammable aerosols
Physical hazards
Liquefied gasGases under pressure
Category 2Skin corrosion/irritation
Health hazards
Category 2Carcinogenicity
Category 2Reproductive toxicity (fertility)
Category 3 narcotic effectsSpecific target organ toxicity, single exposure
Category 1Aspiration hazard
Category 1Hazardous to the aquatic environment, acute
hazard
Environmental hazards
Category 1Hazardous to the aquatic environment,
long-term hazard
Not classified.
OSHA defined hazards
Label elements
Signal word
Danger
Hazard statement
Extremely flammable aerosol. Contains gas under pressure; may explode if heated. May be fatal if
swallowed and enters airways. Causes skin irritation. May cause drowsiness or dizziness.
Suspected of causing cancer. Suspected of damaging fertility. Very toxic to aquatic life. Very toxic
to aquatic life with long lasting effects.
Precautionary statement
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read
and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not
spray on an open flame or other ignition source. Do not apply while equipment is energized.
Pressurized container: Do not pierce or burn, even after use. Extinguish all flames, pilot lights
and heaters. Vapors will accumulate readily and may ignite. Use only with adequate ventilation;
maintain ventilation during use and until all vapors are gone. Open doors and windows or use
other means to ensure a fresh air supply during use and while product is drying. If you experience
any symptoms listed on this label, increase ventilation or leave the area. Avoid breathing mist or
vapor. Avoid breathing gas. Wear protective gloves/protective clothing/eye protection/face
protection. Wash thoroughly after handling. Avoid release to the environment.
1 / 10
Material name: Battery Terminal Protector
1808 Version #: 02 Revision date: 10-30-2013 Issue date: 10-21-2013
SDS US
Evaluation Warning : The document was created with Spire.PDF for .NET.