Cut Sheet

RTV Silicone Adhesive - Gray
DISCLAIMER: This information is accurate to the best of CRC Industries’ knowledge or obtained from sources believed by CRC to be
accurate. Before using any product, read all warnings and directions on the label. All products should be tested for suitability on a particular
application prior to actual use. CRC Industries, Inc. makes no representations or warranties of any kind concerning this data.
CRC Industries, Inc. Industrial Products Division Warminster, PA 18974
Technical Service: [phone] Customer Service: [phone] CRC On-Line: [phone]
Literature Reorder #TDS382 CRC On-Line # 382 REV. 10/13
VII. Directions
 Clean and dry all surfaces. Remove any oil and grease prior to application. Sealant adheres best to clean,
unpainted surfaces.
 For a smooth seal, apply sealant at a 45º angle. Dispense RTV Silicone from the pressurized tube by
pressing finger to nozzle to tilt sideways. RTV Silicone in the cartridge must be dispensed using a caulk
gun. Cut tip of cartridge, screw-on applicator nozzle and cut nozzle to desired bead size.
 If further tooling is required, complete within 5 minutes. Remove excess sealant immediately with a dry
paper towel.
 Normally sealant “skins” in 10 minutes, dries to the touch in one hour and fully cures and bonds in 24
hours.
 If gasket is not used in assembly, apply sealant to surface of one part and allow skin to form before
assembling parts.
 After sealant is completely cured, excess material can be removed by trimming with a sharp blade. Avoid
undercutting the sealant.
 Pressurized tube is re-sealable. If contents are not completely used, extrude 3/8” bead of sealant beyond
the tube opening. When ready to re-use, simply pull out the cured plug.
 Not recommended for use involving continuous immersion in gasoline or head gasketing operations.
VIII. Package Description
Part Number Container Size
14079 12 oz Cartridge
IX. Disposal
Disposal requirements vary by state and local jurisdiction. All used and unused product should be disposed of in
conformance with local, state and federal regulations.
X. Special Use Warnings
Aerosol Cans
Do not puncture, incinerate or store above 120F. Exposure to high temperatures may cause can to burst. Do not
place in direct sunlight or near any heat source. Aerosol cans will conduct electricity. Keep away from all live
electrical sources including battery terminals, solenoids, electrical panels and other electronic components. Failure to
observe this warning may result in serious injury from flash fire and/or electrical shock.
General
Use only in well ventilated area. Ventilation may be improved by opening a window or door or providing mechanical
assistance. Avoid continuous breathing of vapor and spray mist. Avoid contact with skin and eyes. If ventilation is
not adequate, respiratory protection should be worn. For more information regarding short term and long term
exposure, review this product’s Safety Data Sheet.