Manual

page 37 of 720
BIOREMEDIATING parts washing system
SmartWasher
®
USER INSTRUCTION MANUAL
ORIGINAL INSTRUCTIONS
If you are using the FL-4 OzzyMat
®
then you need to
make sure you are peeling away the individual layers on
a weekly basis. Change the entire OzzyMat
®
on the 4th
week OR every month. Make sure to remove any excess
grease, dirt and debris from dirty parts prior to washing.
Does the OzzyMat
®
clog up and cause the fluid
to pool up in the sink?
If the fluid is backing up in the sink and not draining
through the OzzyMat
®
properly, there will be increased
evaporation and the low fluid light may come on
prematurely because the fluid is in the sink, not in
the base.
How many operators and how many hours a
day are you using the SmartWasher
®
?
This will help you determine if they have high, normal
or low usage. If you have higher than normal usage, you
will have higher fluid usage.
When did you notice the change in usage?
If fluid usage has been fine for a period of time and usage
has just recently increased, check to see if anything has
changed recently. (New employees, more employees,
more parts being cleaned, longer hours of use, etc.)
Are operators squeezing the excessive fluid
out of the OzzyMat
®
into the sink after
installing a new OzzyMat
®
?
When changing out the old OzzyMat
®
, squeeze out
any excessive fluid.
What if the fluid has discoloration or gives
odour?
OzzyJuice
®
may become dark in colour due to dyes in
oils or greases removed from dirty parts. This will not
aect its cleaning power. If the fluid should develop a
strong odour, it may be contaminated and you should
call local CRC distributor.