Installation Guide

LPN0245X0001A0_G
TO INSTALL:
RECESSED HOUSING COMPATIBILITY
•TheDRDL6isdesignedtoinstallinstandard6in
recesseddownlighthousings.
• Foralistofcompatiblehousings,visit
www.cree.com/lighting.
• Compatiblewithmostdimmerswhenusedwith
multipleDRDL6xtures.Consult
www.cree.com/lightingforacompatibilitychart.
• Compatibilityofhousingsnotonthislistmaybe
determinedbymeasurementofthehousingas
detailedinthedrawingabove(Figure 1).
IMPORTANT SAFEGUARDS
WARNING - Risk of re or electric shock. Disconnect power
at fuse or circuit breaker before installing or servicing.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. WARNING - Risk of re or electric shock. LED Retrot
Kit installation requires knowledge of luminaires
electrical systems. If not qualied, do not attempt
installation. Contact a qualied electrician.
2. WARNING – To prevent wiring damage or abrasion, do
not expose wiring to edges of sheet metal or other sharp
objects.
3. WARNING – Risk of re or electric shock. Install this
kit only in the luminaires that have the construction
features and dimensions shown in the photographs
and/or drawings.
4. It may be necessary to remove a socket mounting plate
for adequate clearance.
5. Each lampholder shall be installed only in its intended
manner and orientation.
6. Suitable for Wet Locations.
7. Min. temperature rating of -25°C.
8. Do not make or alter any open holes in an enclosure of
wiring or electrical components during kit installation.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE
INSTALLATION INSTRUCTIONS-ENGLISH
DRDL6 Series
LED Downlight
1of2
Minimumdistance
betweenedgeof
xtureandtopof
housingorother
obstruction.
1
Diameter Range
5.5"
5 3/4”-6 1/2"
2
FlipClips
Flip
Clip
STEP 1:
Carefullyrotatethe“FlipClips”
clockwiseuntiltheclipsarefully-
deployed.SeeFigure 2.
STEP 2:
MakesurethePOWER IS TURNED
OFFatthesourcetotherecessed
can.
STEP 3:
Removeexistingtrimandbulb,
revealingtheexistingrecessedsocket.
STEP 4:
ScrewthextureEdisonbaseassembly
intotherecessedcansocketbyturning
clockwise.SeeFigure 3.
STEP 5:
Installxtureupintotherecessed
housingrmlyuntiltrimringisush
withtheceiling.SeeFigure 3 and 4.
3