Installation guide

Crestron FT-600 FlipTop Basic
Setup
Supplied Hardware
The hardware supplied with the FT-600 is listed in the following table.
Supplied Hardware for the FT-600
DESCRIPTION PART NUMBER QUANTITY
Metal, Plate, Mounting 2036985 2
Screw, 10-32 x 2”, Steel, Socket HD, Zinc 2037109 4
Small Hole Plug 2036647 4
Large Hole Plug 2036649 4
Small Bushing, 5/16” ID, 0.5” OD 2009522 4
Large Bushing, 0.55” ID, 0.80” OD 2010496 4
Installation
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
Consideration must be given if installed in a closed assembly, inside a closed desk or
in a closed podium since the operating ambient temperature of these environments
may be greater than the room ambient temperature. Contact with thermal insulating
materials should be avoided on all sides of the unit.
Cable Management Plates
The FT-600 ships with two cable management plates pre-installed. These provide a
pullout cable solution for the cables. Cables are looped through the cable
management plates.
The included bushings must be installed before mounting the FT-600 in a surface.
For a neat appearance, any unused openings can be filled using the included hole
plugs. The only tool required is a Phillips screwdriver.
1. Remove the two cable management plates and retain the 06-32 x 1/4” screw
that holds each one in place.
2. Place the bushings on the cables (eight bushings supplied).
3. Thread the cables through the appropriate slots on each plate.
4. Snap the bushings into the plate slots.
5. Feed all excess cable through the opening.
6. Attach each plate by first sliding its dovetail into the slot toward the rear of
the inside of the FT-600, then dropping the front into place and securing it
with the 06-32 x 1/4” screw from step 1. Refer to the following illustration.
Operations & Installation Guide – DOC. 7596C FlipTop Basic: FT-600 • 9