Use and Care Manual
Section 13A
Smart Set Dial
Section 13A Page 1
Setting up
Section 2A Using Smart Set
™ ®
dial settings
The Smart Set
™ ®
dial is a material selection dial that oers pre-defined settings to get the best results
on paper, vinyl, iron-on, cardstock, fabric, poster board, and more. The Smart Set
™®
dial eliminates the
need to make manual pressure, depth, and speed adjustments. Additional materials can be found
under the Custom setting.
Tip: The Smart Set
™®
dial has been calibrated to work best with Cricut
®
branded products. If settings
don’t cut all the way through the material or if the blade is cutting too deeply into your mat, use the half
settings located between the material markings on the dial, to increase or decrease the pressure.
Paper: Use for text-weight papers such as common computer paper.
Vinyl: Use for adhesive vinyl. Produces a kiss cut. (A kiss cut is when the blade just cuts the top layer
of material and leaves the backing sheet uncut. This makes it easier to weed out leftover pieces after
the cut, and then use transfer tape to apply.)
Iron-on: Use for heat transfer vinyl. Produces a kiss cut. (A kiss cut is when the blade just cuts the top
layer of material and leaves the backing sheet uncut. This makes it easier to weed out leftover pieces
after the cut, and then use transfer tape to apply.)
Light Cardstock: Use for paper rated at 60 – 65 lb. weights, a little heavier than text-weight papers
often found in patterned, printed or decorative papers.
Cardstock: Use for paper rated at 80 – 90 lb. weights, such as playing cards or most solid-colored
crafting papers.
under the Custom setting.
Tip:
The Smart Set
™®
dial has been calibrated to work best with Cricut
™®
dial has been calibrated to work best with Cricut
™®