Use and Care Manual

Step 6 Your machine will detect the cut sensor marks around the images and then make a test cut

around the small center square. When it is ﬁnished cutting, DO NOT unload the cutting mat. While the

mat is still loaded into the machine, take a look at the cut lines around the small square in the middle.

• Click “Yes” and then “Continue” if the cut line touches the printed line all the way around the

small box.

• Click “No” and then “Continue” if the cut line does not match up with the printed line around the

small box. In order to get everything just right, you’ll walk through the same steps we covered here.

Section 15 Page 4

Section 15

Print then Cut Calibration