Remote Starter User Manual

USING THE REMOTE TRANSMITTER

The transmitter supplied with the EZ-90 system has

six buttons. The button configuration of the EZ-90 is

Factory-set and unchangeable. The EZ-91 model

does not include remote transmitters, as it is

designed for the expansion of a “parent” remote

keyless or alarm system. See Page 11 for

additional information on how to use your remote to

operate a second vehicle equipped with an EZ-90

system.

LOCK

TRUNK

REMOTE

UNLOCK

VEHICLE 2

FLASHLIGHT

START

NOTE: BUTTON #4 Remote Start

There is a deliberate delay built into the system on

button #4 to help prevent accidental remote starting

from the remote being in your pocket or purse.

During normal use, press button #4 for at least 1

second to trigger a remote start.

REMOTE ENGINE CONTROL

REMOTE ENGINE STARTING - SUCCESSFUL START:

1) Press the remote start button for at least 1 second. (For EZ-91 models, activate Green Start input wire.)

2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on.

3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off while cranking.

4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock.

5) Engine will remain running for programmed run time until reset it is reset with Brake pedal.

AFTER

IGN

STARTER

THEN

FLASH 1X

SOLID

SEC.