Remote Starter User Manual

CONVENIENCE AND SAFETY FEATURES
VALET MODE / STARTER DISABLE OVERRIDE
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode.
The remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON
position, press and hold Program/Valet switch for 5-6 seconds. The LED will turn on solid and the system is now
in valet. Perform this procedure again to exit of Valet mode. The keyless entry will still function normally while in
valet mode. In the event of a lost or broken transmitter, perform this step to override the Starter Disable (if
installed).
ANTI GRIND / STARTER DISABLE (Optional, relay not included)
This optional feature prevents the user from accidentally grinding the starter if the Ignition key is turned too far to
the start position while engine is already running from the remote starter. The Anti Grind/Starter Disable requires
the use of an external relay. This system must be programmed to allow this relay to work as a starter disable.
PASSIVE STARTER DISABLE (Optional)
This EZ-90 includes a programmable feature to allow the Optional Starter Disable to activate automatically 1
minute after the ignition is turned off. This programmable feature may provide insurance discounts for “Passive
Security” functions, or meet an insurance requirement in your state or province.
HOOD OPEN SAFETY (Requires grounding hood pin installation)
Prevents the engine from being Remote Started when hood is open. Helps eliminates risk of injury to someone
working under the hood of the vehicle with a properly working hood pin installed. If Remote Start button is pressed
with the hood open, the lights will flash once and the unit will not attempt a start.
BRAKE PEDAL RESET
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. (Helps prevent
unauthorized tampering). This circuit shuts the system down immediately when brake pedal is pressed if the key
is not in ignition and turned to the ON position.
OEM ALARM INTERFACE
This feature is designed to Disarm and Re-arm Factory equipped security systems in conjunction with remote start
and keyless entry (if needed for your vehicle). This feature will maintain the original integrity and security of your
vehicle’s factory equipped systems before, during, or after remote start.
NOTE:
When changing, charging, or jumpstarting the vehicle’s battery we recommend removing the main power fuses
located on the heavy gauge RED wires near the remote start main control module.
9