Operating instructions

REMOTE ENGINE CONTROL

REMOTE ENGINE STARTING - SUCCESSFUL START:

1) Press the remote start button for at least 1 second.

2) Parking lights flash once; return solid, and the Ignition/Accessory circuits turn on.

3) After a few seconds the Starter Motor engages, Parking lights and Accessory circuits will turn off while

cranking.

4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock.

5) Engine will remain running for programmed run time until it is reset with Brake pedal.

AFTER

IGN

STARTER

THEN

FLASH 1X

SOLID

SEC.

REMOTE ENGINE STARTING - UNSUCCESSFUL START

In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then attempts to

restart the engine a 2

and 3

time. For hard starting engines, the unit will allow a starter crank time of up to10 seconds

maximum. This should provide ample cranking time for difficult starts, but is limited to 10 seconds to help prevent damage

to the starter from over cranking.

1) If the engine starts on 2

or 3

attempt, see steps 4 & 5 above of "Successful Start".

2) If Third attempt fails to start engine, the system will turn off and doors will remain locked. NO FURTHER ATTEMPTS

WILL BE MADE AUTOMATICALLY

TURNING OFF A REMOTE STARTED ENGINE:

1) Engine is running in Remote Start (Parking lights ON).

2) Press and release the remote start button

3) Engine & parking lights OFF.

REMOTE START RUN TIME RESET:

You can reset the engine-run timer to allow for more running time after remote start has already occurred

using the remote control. After a successful remote start, press both the Lock & Unlock buttons together for at

least 2 seconds. The parking lights will flash 3 times and the internal engine timer will reset back to zero

minutes.