PART LIST = [E] & Top Panel Left Panel Right Panel Bottom Panel Front Rail 1PC 1PC 1PC 1PC 1PC Left Door Right Door Adjustable Shelf Back Panel Drawer Front Pane! 1PC 1PC PCS 1PC 1PC Drawer Left Pane! 1PC Drawer Right Panel 1PC Drawer Back Panel 1PC Drawer Bottom Panel 1PC
HARDWARE LIST ADDITIONAL TOOLS (Not Provided) Note: It is not recommended to use power tools during assembly. = Phillips Head Screwdriver Note: Wood dowels are intended for alignment. Additional clearance between wood dowel and per-drilled hole is intentional for ease of assembly.
Step 1. Attach double magnet (part #6) to front rail (part E) using screws (part #7) and fillips head screwdriver. Attach handle (part #3) to drawer front panel (part J} using short bolts (part #4) and fillips head screwdriver. Step 2. Attach drawer panels (parts drawer back panel (part M) using long screws (part #8) and fillips head screwdriver.
Step 3. Slide drawer bottom panel (part N} into grooves of assembled unit (parts Step 4. Attach drawer front panel (part J) to assembled unit (parts using long screws (part #8) and fillips head screwdriver.
Step 5. Attach handles (part #3) to doors (parts F & G) using short bolts (part #4) and fillips head screwdriver. Step 6. Attach panels (parts bottom panel (part D) using wood dowels (part #2).
Step 7. Attach long bolts (part #1) to assembled unit (parts using Allen wrench (part #10). Step 8. Attach top panel (part A) to assembled unit (parts B & C) using wood dowels (part #2), long bolts (part #1) and Allen wrench (part #10).
Step 9. Attach font rail (part E) to assembled unit (parts B & C) using wood dowels (part #2), long screws (part #8) and fillips head screwdriver. Step 10. Attach back panel (part |) to assembled unit (parts using short screws (part #9) and fillips head screwdriver.
Step 11. Carefully turn unit upright. Slide assembled drawer into place. Note: Place the slid able part to the front position before sliding in.
Step 12. Attach doors (parts placing bottom pin hinge (per-installed in door) in the per-drilled hole of bottom panel (part D). Then depress the top spring-loaded pin hinge so it can be placed in the per-dilled hole of front rail (part E). Note: Be sure top and bottom pin hinges are fully extended to secure doors in place. Note: It is important to adjust levelers once fully assembled and upright. Extend adjustable leveler until it's firmly in contact with the floor.
Step 13. Place shelf holders (part #5) into desired position and slide adjustable shelves (part H) into place. Important: Safety strap kit (part #11) must be installed to prevent tipping, damage and/or injury.
Step 14. #11] Lge Safety Strap Kit Long Screw Wall Anchor Short Screw Safety Wall Strap Flat Washer 18ET 1PC 1PC 1PC 1PC 1PC SAFETY WALL STRAP INSTALLATION Note: It is highly recommended to install this safety strap kit to prevent tipping, damage and/or injury. 1. Insert short screw (C) through flat washer (E) and safety wall strap (D) and attach to top panel (part A) using fillips head screwdriver. 2. Drill a 11/32" hole where you want to secure the unit.