PART LIST Top Panel Bottom Panel Left Side Panel Right Side Panel Adjustable Shelf 1PC 1PC 1PC 1PC 1PC Leg Back Panel Left Door Panel | Right Door Panel | Back Connecting Rail 4 PCS PCS 1PC 1PC 1PC
HARDWARE LIST ADDITIONAL TOOLS (Not Provided) Note: It is not recommended to use power tools during assembly.
Please do not use tools to assemble this unit unless specifically indicated. Reference the images above any time the instructions state "lock the hardware". Note: Be sure to check all hardware is locked when completed. Note: Wood dowels are intended for alignment. Additional clearance between wood dowel and per-drilled hole is intentional for ease of assembly. Step 1. Lay bottom panel (part B) upside down on a soft surface, such as carpet, as shown below.
Step 2. Attach door hinges (part #5) to left door panel (part H) and right door panel (part I} using small screws (part #6) and fillips head screwdriver. Attach handles (part #7) to left door panel (part H) and right door panel (part I) using round head bolts (part #8) and fillips head screwdriver. #5 x4 #6 Queue Step 3. Attach left side panel (part C) and right side panel (part D) to top panel (part A) using Allen wrench (part #2), wood dowels (part #3) and medium bolts {part 4).
Step 4. Attach assembled unit (parts assembled unit (parts using Allen wrench (part #2), wood dowels (part #3), long bolts (part #11) and lock the hardware. amm x6 #1114 Step 5. Carefully turn unit upright. Attach back panels (part G) to assembled unit (parts using large screws (part #10) and fillips head screwdriver.
Step 6. Insert shelf holders (part #9) into desired position on left side panel (part C) and right side panel (part D). Slide adjustable shelf (part E) into place. # O x4 Step 7. Attach left door panel (part H) to left side panel (part C) using installed door hinges (part #5), small screws (part #6) and fillips head screwdriver.
Step 8. Attach right door panel (part I} to right side panel (part D) using installed door hinges (part #5), small screws (part #6) and fillips head screwdriver.
3/4° D8 x % Safety Strap Kit| Wall Anchor Washer Short Screw Long Screw | Safety Wall Strap 1PC 1PC PCS 1PC 1PC 1PC SAFETY WALL STRAP INSTALLATION Note: It is highly recommended to install this safety strap kit to prevent tipping, damage and/or injury. 1. Insert short screw (C) through washer (B) and safety wall strap (E) and attach to back of top panel (part A) using fillips head screwdriver. 2. Drill a hole where you want to secure the unit.
ADJUST YOUR DOORS TO MAKE THE GAPS MORE EVEN (OPTIONAL). STEP Open the door TOP PANEL STEP 2 STEP 2a MOVE DOOR IN STEP 2b MOVE DOOR OUT Adjust the gap between door panel and side panel \ \ TOP PANEL TOP PANEL SIDE PANEL too small gap SIDE PANEL big gap DOOR TOP PANEL TOP PANEL TOP PANEL Loosen the screw indicated a little, adjust the hinge to right position {(see step 2a & 2b), then tighten the screw. Push the hinge back a little. Pull the hinge forward a little.