PART LIST Top Panel Left Panel Right Panel Back Panel Bottom Panel 1PC 1PC 1PC 1PC 1PC F G H Glass Door Fixed Shelf Support Plate 1PC PCS 1PC
HARDWARE LIST [1777 > EE 1/4" $8x30mm Long Bolt Short Bolt Spring Washer Flat Washer Wood Dowel 4 PCS 8 PCS 12 PCS (Extra 1) | 12 PCS (Extra 1) | 10 PCS (Extra Soe 0 [« Sm ©3.5x14 mm #8x38mm Door Hinge Screw Knob Round Head Bolt Long Screw PCS 12 PCS (Extra 1) 1PC 1PC PCS #11 #12 #13 [oo] ® Wall Anchor Allen Wrench Adhesive Pad PCS 1PC PCS ADDITIONAL TOOLS (Not Provided) Note: It is not recommended to use power tools during assembly. & Phillips Head Screwdriver Note: Wood dowels are intended for alignment.
Step 1. Attach knob (part #8) to glass door (part F) using round head bolt (part #9) and fillips head screwdriver. Attach door hinges (part #6) to glass door (part F) using screws (part #7) and fillips head screwdriver. Step 2. Attach back panel (part D) to left panel (part B) using wood dowels (part #5), long bolts (part #1), spring washers (part #3), flat washers (part #4) and Allen wrench (part #12).
Step 3. Slide fixed shelves (part G) to left panel (part B). Step 4. Attach right panel (part C) to back panel (part D) and fixed shelves (part G) using wood dowels (part #5), long bolts (part #1), spring washers (part #3), flat washers (part #4) and Allen wrench (part #12).
Step 5. Attach top panel (part A) to assembled unit (parts using wood dowels (part #5), short bolts (part #2), spring washers (part #3), flat washers (part #4) and Allen wrench (part #12). #12-Ix Step 6. Attach bottom panel (part E) to assembled unit (parts using wood dowels (part #5), short bolts (part #2), spring washers (part #3), flat washers (part #4) and Allen wrench (part #12).
Step 7. Attach glass door (part F) to right panel (part C) using screws (part #7) and fillips head screwdriver. Attach adhesive pads (part #13) into glass door (part F). Adjust these screws to balance the #7 = X8 spacing of the doors.| #13 @ X2 Step 8. Drill three 11/32" holes in the wall and tap wall anchors (part #11) into the drilled holes. Secure support plate (part H) to wall anchors (part #11) using long screws (part #10) and fillips head screwdriver.