Specifications

Control Testing Procedures
!
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to range before servicing, unless
testing requires power.
© 2005 Maytag Services 16026784 15
Control Feature Test Procedure Results
M1 Oven temperature
adjustment
Press Bake pad.
Enter 550 on the digit-pad.
Immediately press and hold Bake pad
for 3 to 5 seconds.
Oven can be adjusted from -35 to +35
degrees in 5-degree increments by
pressing More + or Less - pads. To
avoid over adjusting the oven, move
temperature 5 degrees each time.
Wait 4 seconds for the data entry timer
to expire to accept the change.
Temperature adjustment will be
retained even through a power failure.
While increasing or decreasing oven
temperature, this does not affect self-
cleaning temperature.
M1 Temperature display Press and hold Cancel and Bake
pads for 3 to 5 seconds. Press
More + or Less - pads to change.
This mode enables the user to indicate
°F or °C on the display.
M1 Clock display Press and hold Cancel and Clock
pads for 3 to 5 seconds.
Allows clock to be toggled on or off.
M1 24-hour clock Press and hold Cancel and Delay
pads for 3 to 5 seconds. Press
More + or Less - pads to change.
Allows the time on the clock to be
toggled from 12-hour or 24-hour display.
M1 Factory default Press and hold Cancel and Keep
Warm pads for 3 to 5 seconds until
beep sounds.
Allows the clock to be reset to factory
settings.
M1 12-hour off Control automatically cancels cooking
operations and removes relay drives
12 hours after the last pad touch.
See Sabbath mode to disable.
M1 Sabbath mode Hold Clock pad for 3 to 5 seconds to
activate Sabbath mode.
Hold Clock pad for 3 to 5 seconds to
disable Sabbath mode.
Initiate desire bake function before
entering Sabbath mode.
"SAb" flashes for 5 seconds then remain
on until timed-out or cancelled.
The status "SAb" is NOT fault code 5A6.
All pad inputs are disabled except for
CANCEL and CLOCK pads.
This mode disables the normal 12 hour
shutoff to allow operation of the bake
mode for a maximum of 72 hours.
The oven light is not disabled.
M1 Child lockout Press and hold Cancel and Cook &
Hold pads for 3 to 5 seconds until
beep sounds.
To reactivate the control, press and
hold Cancel and Cook & Hold pads
for 3 to 5 seconds.
This safety feature is used to prevent
children from accidentally programming
the oven (the electronic range control is
completely disabled).
Child lockout features must be reset after
a power failure.
M1 Diagnostic code
display
Press and hold More + pad within 30
seconds of powering up the unit.
Cycle through the codes using the
More + or Less - pads.
The last 5 diagnostic codes will be stored
in the non-volatile memory.
See "Description of Error Codes" for
explanation.