- Crown Operation Manual Power Amplifier 140MPA

Commercial Audio Series Mixer-Amplifiers

page 12

Operation Manual

2.8 Remote Volume Control

You can remote-control the output volume of the 140MPA. To do so,

locate the OUTPUT VCA connector on the back panel. Insert a 4-pin

Phoenix-type cable connector into the OUTPUT VCA connector. Wire a

Crown 1-VCAP level control to the Phoenix-type cable connector ter-

minals as shown in Figure 2.12.

Figure 2.12 Wiring a 1-VCAP Level Control

to the Output VCA Connector

Phoenix-type

plug

Output VCA Connector

2 Setup