User's Manual

ManualsBrandsCrown Audio ManualsAmplifiersDCI 4|1250ND DriveCore Install 4-Channel 1250W Network Display Amplifier with AVB

DriveCore Install Network Series Power Ampliﬁers

page 19

Operation Manual

Each ampliﬁer can be dragged into the room window. Each device will have a IP address listed on the left of the ampliﬁer and a Name ID on the right on the ampliﬁer. The

Name ID can be edited in the properties menu at the bottom of the page. The number to the left of Name ID is the HiQnet Device Address. The green circle only indicates

that the ampliﬁer has been discovered on the network. The small box located below the rack allows quick access to ampliﬁer factory panels. These panels include the

following items. Note: When a device is added to the window, it is automatically removed from the "Discovered" section.

• Factory host

Panels

• Monitor Panels

• Meter Panels

• Level and Mute Panels

Double clicking an ampliﬁer will access the ampliﬁer factory control panel. At this point, Audio Architect is in OFFLINE MODE. In OFFLINE MODE, ampliﬁer changes are

not made in real time and will need to be sent to the ampliﬁers. Ampliﬁer changes can also be sent in real time in ONLINE MODE. To go to ONLINE MODE, click on the GO

ONLINE tab in the Workﬂow bar menu. RECEIVE and SEND buttons will appear for each device, rack, and room in the design. This gives the user the option to just update a

single device, all devices in a rack or an entire venue. Click SEND to load the settings made in Audio Architect to the ampliﬁer. Click RECEIVE to read the settings off of the

ampliﬁer to be reﬂected in Audio Architect.

Figure 11

Figure 12