User's Manual
DriveCore Install Network Series Power Amplifiers
Operation Manual
page 24
Set-up and System Conguration
Bridge Mode (16Ω, 8Ω, or 4Ω) Output Operation
Typical input and output wiring, along with software settings
are shown in Figure 21.
INPUT WIRING: If using analog inputs, it is only necessary to
wire the odd number inputs. If using the BLU link input, it is
important to understand that BLU link is a digital audio bus
and cannot be routed through a network switch or router. To
increase fault protection, use both the input and output BLU
link wiring connection. For BLU link routing, refer to page
33.
OUTPUTS: Connect the speaker across the positive terminals
of each channel pair. Do not use the negative terminals of
the channel pair when the pair is being operated in Bridge
Mono mode.
Figure 21 System Wiring Bridge Mode
Figure 22 The bridge mono checkbox must be checked for proper operation
Always route the input and output wires in separate bundles.