User's Manual

DriveCore Install Network Series Power Amplifiers
page 57
Operation Manual
AC Power Draw and Thermal Dissipation
AC Power Draw and Thermal Dissipation:
Pink noise 12dB crest factor, bandwidth limited 22Hz to 22kHz.
Typical line impedance used.
Data based on all channels driven.
DCi 2|600N - Bridge
120 VAC / 60 Hz 230 VAC / 50 Hz
Condition Load
"Line
current
(amps)"
Power Dissipated as Heat "Line
current
(amps)"
Power Dissipated as Heat
watts BTU kcal/hr watts BTU kcal/hr
At Idle Awake N/A 0.6 71 241 61 0.4 66 226 57
1/8 Power
Pink Noise
Typical of program
material just at clip
4Ω 1. 4 90 308 78 0.8 91 311 78
8Ω 2.2 101 344 87 1. 2 101 344 87
16Ω 2.1 94 321 81 1. 1 92 314 79
140Vrms (16Ω) 2.1 93 318 80 1. 1 91 312 79
200Vrms (33.33Ω) 2.0 86 295 74 1. 1 84 287 72
1/3 Power
Pink Noise
Typical of program
material at
extreme clip
4Ω 2.8 128 438 110 1. 6 133 453 114
8Ω 4.8 157 536 135 2.5 148 505 127
16Ω 4.6 130 444 112 2.3 118 403 102
140V (16Ω) 4.6 125 427 108 2.3 117 399 101
200V (33.33Ω) 4.4 106 363 91 2.3 105 358 90
DCi 2|600N - Dual
120 VAC / 60 Hz 230 VAC / 50 Hz
Condition Load
"Line
current
(amps)"
Power Dissipated as Heat "Line
current
(amps)"
Power Dissipated as Heat
watts BTU kcal/hr watts BTU kcal/hr
At Idle Awake N/A 0.6 70 240 60 0.4 71 241 61
1/8 Power
Pink Noise
Typical of program
material just at clip
2Ω 1. 6 102 348 88 0.9 93 319 80
4Ω 2.3 107 364 92 1. 2 104 355 89
8Ω 2.2 98 333 84 1. 2 96 328 83
70V (8Ω) 2.2 96 329 83 1. 2 94 322 81
100V (16.67Ω) 2.0 87 297 75 1. 1 87 298 75
1/3 Power
Pink Noise
Typical of program
material at
extreme clip
2Ω 3.0 142 486 122 1. 6 134 456 115
4Ω 4.8 161 549 139 2.5 153 521 131
8Ω 4.5 131 446 112 2.4 129 441 111
70V (8Ω) 4.5 130 442 111 2.3 122 417 105
100V (16.67Ω) 4.5 122 417 105 2.4 109 370 93