Software Instruction Manual

IQ–MSD Turbo 1.4 Advanced IQ System Software
Page 10
C
6.18 The Fifth AMB-5 Sub-block Screen ............................................................................................................... 159
7.1 A Typical Equalizer Control Block Screen .................................................................................................... 163
7.2 The Input/Output Level Bar Graphs on an Equalizer GDM ............................................................................ 164
7.3 A Typical Equalizer Control Block ................................................................................................................ 165
7.4 A Sample Equalizer GDM ............................................................................................................................. 166
8.1 A Drone Control Block Screen ...................................................................................................................... 169
8.2 Sample Objects Used to Monitor a Drone ..................................................................................................... 170
8.3 The Drone Object Attributes Window ............................................................................................................ 173
8.4 The Drone Aux Input Setup Sub-block Screen .............................................................................................. 174
8.5 The Drone Simplex Input Commands Sub-block Screen .............................................................................. 175
8.6 Adding a Command Assignment to a Simplex AUX Input ............................................................................. 176
8.7 Selecting an Existing Drone Command Assignment ..................................................................................... 179
8.8 Adding a Command Assignment to a Binary AUX Input ................................................................................ 181
8.9 Adding a Command Assignment to an Analog Input ..................................................................................... 182
8.10 Adding a Command Assignment to an AUX Output ...................................................................................... 184
8.11 Adding a Paralyze Command Assignment to an AUX Input .......................................................................... 186
8.12 Adding a Paralyze Command Assignment to an Analog Input ....................................................................... 187
8.13 The Drone Control Block with the Transponder Switch Enabled ................................................................... 188
9.1 The Matrixer Control Block Screen .............................................................................................................. 189
9.2 Monitoring & Controlling a Matrixer from a Graphics Plate ............................................................................. 191
10.1 The PSI Control Block Screen ..................................................................................................................... 193
10.2 Monitoring & Controlling a PSI from a Graphics Plate ................................................................................... 194
11.1 An SLM-8 Control Block Screen ................................................................................................................... 195
11.2 The SLM-8 Setup Sub-block Screen ............................................................................................................ 196
11.3 A Sample Impedance Curve ........................................................................................................................ 197
11.4 A Sample Graphics Plate Plotter Object with Two Curves ........................................................................... 197
11.5 The SLM-8 Setup Sub-block Screen ............................................................................................................ 198
11.6 Exporting Data to a DIF File .......................................................................................................................... 202