Software Instruction Manual

IQ–MSD Turbo 1.4 Advanced IQ System Software
Page 141
6.4 Automated Controls
The real power of the IQ mixers with sensing capability (SMX-6s and AMB-5s) is their ability, once configured, to
run automatically. The automatic functions are configured from a series of Sub-block screens. Note: Because the
MPX-6 has no level sensors, it has no automatic functions and therefore no sub-blocks. To switch to the first Sub-
block screen, select the ASA control in the control block of the desired mixer and press either
E or Y.
The above illustration shows only the first SMX-6 Sub-block screen. There are four SMX-6 Sub-block screens
and five AMB-5 Sub-block screens. Use
O N to move from one Sub-block screen to the next. And use }
~ to move from the first sub-block screen to the last. We shall use SMX-6 Sub-block screens for most of the
illustrations in this section. Bear in mind, however, that only Channel 1 of AMB-5 mixers is capable of automatic
control so there are no controls for Channel 2 in the AMB-5 sub-blocks. Figure 6.10 depicts this difference—it is
the AMB-5 version of Figure 6.9.
Fig. 6.9 The First SMX-6 Sub-block Screen
Fig. 6.10 The First AMB-5 Sub-block Screen