Software Instruction Manual

IQ–MSD Turbo 1.4 Advanced IQ System Software
Page 177
Attenuation—set the input attenuation level of each channel
All Power—turn on/off the high voltage supplies of ALL amplifiers in one zone
All Mute—mute/unmute the input of ALL amplifiers in one zone
All DSPI—force the DSPI lights of ALL relevant amplifiers to stay on in one zone
Amplifier IQ P.I.P. with SmartAmp features (includes all the above commands plus):
ASA—turn on/off all automation functions
ODEP Conservation—enable automatic gain reduction as ODEP level rises
Smooth Output Limiter—enable “smooth” output limiting
Smooth Output Limiter Threshold—set the point when smooth limiting begins
Stand By—enable standby mode when no signal present
Stand By Gate Level—set the point when the high voltage supplies turn on
Stand By Turn Off Delay—disable turn-on delay while using standby mode
Fault Error Reporting—show an alert message if a fault occurs
Fault Error Input Drive Level—set the minimum drive level for a fault
Report Fault Via AUX—turn on AUX port if a fault occurs
IOC Error Reporting—show an alert message if an IOC error persists
Short Error Reporting—show an alert message if a short is detected
DSPI Flash—this control is reserved for future use
Break Detect—disable break detect when not connected to an IQ System
MPX-6 Mixer:
DSPI—force Data Signal Presence Indicator to stay on
AUX—turn on/off AUX port output
Bus—turn on/off the audio Bus output of each channel
Attenuation—set the attenuation level of each input and channel
SMX-6 Mixer (includes all MPX-6 commands plus):
ASA—turn on/off all automation functions
Max Gain Tracks Control Block—makes Max Gain of each input equal to the control block gain settings
Control Block Override—this control is reserved for future use
Max Gain—set the maximum gain for an input and channel
Low Set—set the “closed gate” gain for an input and channel
Gate Algo—turn on/off the Gate function
Gate Threshold—set the point when an input gate “opens”
Duck Priority—turn on/off the Duck Priority function
Input Compression—turn on/off the Input Compressor/Limiter function
Input Compression Threshold—set the point when input compression begins
Auto Level—turn on/off the Auto Level function
Auto Level DAOL—set the Desired Average Output Level of each input and channel
Idle Gain—set the initial level for the Auto Level function when a gate “opens”
Output Compression—turn on/off the Output Compressor/Limiter function
Output Compression Threshold—set the point when compression begins
Output Limiter—select which inputs and channels are compressed
Gate Count Master—turn on/off the Gate Count function
Gate Count—turn on/off gate counting for each input
Lock (Attenuation)—locks output Channel 1 and 2 so that attenuation changes to one also affect the other
Lock (Max Gain)—locks output Channel 1 and 2 so that changes to the Max Gain setting of one also affect the
other